What to Use as Wheel Chocks: Materials and Alternatives
A practical guide to wheel chock selection: compare rubber, plastic and wood chocks, match chock size to tire size, and learn safe chock placement.
Contents
What to use as wheel chocks comes down to a material that grips the tire and holds its shape under the load, matched to the tire and the ground. Rubber, plastic and wood each behave differently under a rolling wheel, and the chock load rating tells you what a chock is built to hold. This page explains chock materials, chock sizing and placement, and which improvised chocks are safe to use.
Rubber, plastic and wood compared
Rubber chocks grip a tire well because the material deforms slightly and resists sliding on hard ground. Plastic chocks are lighter to carry but can crack or skid when a heavy tire pushes against a thin edge. Wood blocks work as a cheap alternative when the grain runs across the load and the block is wide enough for the tire. A solid rubber chock suits a workspace where the same tire is measured again and again.
Why the chock load rating matters
A chock load rating states the weight a chock is designed to hold against rolling, and it should exceed the load you are blocking. Chock material durability decides whether the chock keeps that rating after repeated contact with a tire and rough ground. A chock that has worn edges or deep cuts no longer holds its rated load. Check the rating marked on the chock before you trust it under a heavy vehicle.
Matching chock size to the tire
Chock size for a tire depends on the tire diameter and the gap between the tread and the ground. A chock that is too short lets the tire roll over it, while an oversized chock can foul the tread before it seats. Chock sizing also accounts for the slope of the ground, because a steeper surface demands more chock height. Set the chock against the tread so the curved face meets the tire squarely.
Wheel Chock Questions Answered
What can I use as wheel chocks if I have none?
Improvised chocks can be a solid wood block or a wedge cut to fit the tire, provided the material is rigid and wide enough. Loose bricks, stones or soft foam do not hold a tire and can shoot out under load. An improvised chock should be treated as a temporary measure only, and a rated chock is the safer choice for any tire you are working around.
Are plastic wheel chocks safe?
Plastic wheel chocks are safe when the plastic is thick, the load rating covers your tire and the ground is firm and flat. Thin plastic chocks can crack under a heavy tire or slide on a smooth surface. Inspect a plastic chock for cracks and worn edges before each use, and replace it once the body shows damage.
How do I choose between rubber and plastic chocks?
Rubber chocks resist sliding and absorb contact with the tire, which suits hard floors and repeated use. Plastic chocks are lighter and easier to move but depend on a thick wall and a sound load rating. Choose rubber for grip on smooth ground and plastic where weight matters and the load stays within the rating.
Where should a wheel chock sit on the tire?
A wheel chock sits against the tread on the downhill side of the tire, pressed into the gap where the tire meets the ground. Place it so the chock face contacts the tread squarely rather than the sidewall. On a slope, chock the wheel on the side the vehicle would roll toward, and use a chock sized for that tire.