UK Legal Tyre Tread Depth Limit
The UK legal tyre tread depth limit explained: the 1.6 mm minimum across the central three-quarters, where to measure, MOT checks and the risks of illegal tread.
Contents
- What the UK tread depth law requires
- Where to measure tread across the tyre
- How to check tread depth at home
- What happens when tread is below 1.6 mm
- MOT checks and tread depth
- Winter, summer and all-season tyres
- Reading the numbers on the sidewall
- Questions about UK tyre tread rules
- What is the legal tread depth limit in the UK?
- Is the 1.6 mm limit measured across the whole tyre?
- Does a tyre under the legal limit fail an MOT?
- What are the penalties for illegal tyre tread?
- Can tread wear indicators show when a tyre is at the limit?
- Do winter tyres have a different legal limit?
The UK legal tyre tread depth limit is 1.6 mm, measured across the central three-quarters of the tread width around the entire circumference. Tyres on cars and similar light vehicles must meet this minimum to be legal on the road. A tyre below the limit fails an MOT tyre check and must not be used.
- The legal minimum tread depth for cars in the UK is 1.6 mm.
- Measure across the central three-quarters of the tread, all the way around the tyre.
- Tread wear indicators inside the grooves show when the limit is near.
- A tyre under the limit is illegal and fails an MOT check.
- Grip in wet conditions falls sharply as tread wears toward the limit.
What the UK tread depth law requires
UK tread depth law sets a minimum of 1.6 mm for tyres fitted to cars and light vehicles. The Road Vehicles Regulations and the Road Traffic Act tyre rules make this a legal requirement, not a recommendation. A tyre that does not meet the minimum is not legal for road use.
The 1.6 mm figure applies to the tread pattern, not to the sidewall or any raised lettering. The limit is a single number that covers the whole legal tread area. Drivers can check their tyres against it at any time with a gauge.
The law addresses the condition of the tyre as fitted to the vehicle, so a spare carried in the boot is not part of the road contact set. The rules apply while the vehicle is used on a public road. Checking tread before a journey keeps the vehicle within the law.
Where to measure tread across the tyre
The legal minimum applies across the central three-quarters of the tread width, not the whole face of the tyre. The outer quarters near the shoulders are outside the legal measurement zone. Measurements must still be taken at several points around the circumference.
A tyre can pass at one spot and fail at another, so check more than one position. Measure in each main circumferential groove at points spaced around the tyre. The lowest reading found in the central three-quarters is the figure that counts.
Wear is often uneven, with one edge or one section wearing faster. Uneven wear can point to alignment or inflation problems that deserve attention. Recording the lowest reading gives a clear answer on whether the tyre is legal.
- Find the central three-quarters of the tread width.
- Measure in each main groove at several points around the tyre.
- Use a tread depth gauge for an accurate reading.
- Note the lowest figure found in that central zone.
- Compare the lowest figure with the 1.6 mm limit.
How to check tread depth at home
A tread depth gauge gives the clearest reading of the remaining tread. The gauge probe sits in a groove and the scale shows the depth in millimeters. A cheap gauge is enough for a useful check, and many drivers keep one in the car.
Tread wear indicators are raised bars inside the main grooves that show when the limit is near. When the tread surface sits level with the indicator, the tyre is at the wear limit. Indicators give a quick visual guide between gauge checks.
A visual look at the tread blocks and the wear pattern also helps. Cracking, cuts or bulges matter as much as depth and can make a tyre unfit. A trained technician should assess any damage that looks serious.
What happens when tread is below 1.6 mm
A tyre below the 1.6 mm limit is illegal and fails an MOT tyre check. Penalties for illegal tread can include a fine and penalty points on the licence. Each illegal tyre counts separately, so the exposure grows with the number of worn tyres.
The safety effect matters more than the penalty. Tread channels water away from the contact patch, and a shallow pattern clears less water. Wet grip and braking distance worsen as depth falls toward the limit.
A tyre at the limit should be replaced rather than run further. Replacement is a job for a tire technician with the right equipment. Fitting and balancing need proper tools and training, so leave the work to a specialist.
MOT checks and tread depth
The MOT tyre check tests tread depth against the 1.6 mm minimum. A tester examines the tyres fitted to the vehicle and records any that fail. An illegal tyre means the vehicle does not pass the test.
The check covers tread depth and the general condition of each tyre. Cuts, bulges and exposed cords are assessed alongside the depth reading. A tyre that is legal on depth can still fail on condition.
Checking tread before the test date avoids a surprise failure. A simple gauge check at home shows whether any tyre sits near the limit. Replacing worn tyres ahead of the test keeps the vehicle legal.
Winter, summer and all-season tyres
The 1.6 mm limit applies to tyres on cars whatever their seasonal type. Summer, winter and all-season tyres all fall under the same UK legal minimum. The tyre type does not change the legal figure.
Winter tyres carry more tread depth when new, so they have further to wear before reaching the limit. That extra depth helps in cold and wet conditions. All-season tyres sit between the two in their starting depth.
Tread depth alone does not decide how a tyre performs in cold weather. The rubber compound and the tread pattern also matter. A worn winter tyre still fails the legal minimum once it reaches 1.6 mm.
Reading the numbers on the sidewall
The sidewall of a tyre carries its size and specification, and those numbers help when ordering a replacement. A size such as 205/55 R16 gives the width, the aspect ratio and the wheel diameter. The load index and speed rating follow the size.
Sidewall markings do not state tread depth, so depth must be measured directly. The numbers describe the tyre's dimensions and its rated limits. Reading them correctly avoids fitting the wrong size.
Matching the new tyre to the old one keeps the vehicle's geometry and speedometer reading consistent. A technician can confirm the correct size for the wheel. The sidewall numbers are the starting point for that conversation.
Questions about UK tyre tread rules
What is the legal tread depth limit in the UK?
The legal tread depth limit in the UK is 1.6 mm for tyres on cars and light vehicles. The measurement applies across the central three-quarters of the tread width around the whole tyre. A tyre below that figure is illegal for road use.
Is the 1.6 mm limit measured across the whole tyre?
No, the 1.6 mm limit is measured across the central three-quarters of the tread width. The outer quarters near the shoulders fall outside the legal measurement zone. Readings should still be taken at several points around the circumference.
Does a tyre under the legal limit fail an MOT?
Yes, a tyre below the legal tread limit fails an MOT tyre check. The tester records the tyre as a failure and the vehicle does not pass. Replacing the worn tyre before the test avoids that outcome.
What are the penalties for illegal tyre tread?
Penalties for illegal tread can include a fine and penalty points on the licence for each illegal tyre. The exact outcome depends on the circumstances and the decision of the court. A tyre below 1.6 mm should be replaced before the vehicle is driven.
Can tread wear indicators show when a tyre is at the limit?
Yes, tread wear indicators are raised bars in the main grooves that show when the tread is close to the limit. When the tread surface sits level with an indicator, the tyre is at the wear limit. A gauge gives the precise figure in millimeters.
Do winter tyres have a different legal limit?
No, winter tyres on cars face the same 1.6 mm legal minimum as summer and all-season tyres. Winter tyres start with deeper tread, so they take longer to reach the limit. The legal figure stays the same whatever the tyre type.