Legal Tread Depth Limit for HGV and Truck Tyres
Learn the legal tread depth limit for HGV and truck tyres, how the steer axle and drive axle rules differ, and how a commercial vehicle tyre inspection is done.
Contents
- Minimums by axle position
- How tread depth is measured
- Why groove depth matters
- Questions about truck tyre tread minimums
- What is the legal tyre tread depth limit for an HGV?
- Is the legal tire tread depth for commercial vehicles the same on every axle?
- What is the legal tire tread depth for a semi truck?
- How do I check my truck tyres during a commercial vehicle tyre inspection?
The legal tread depth limit for HGV and truck tyres depends on the axle, because a steering axle must carry a deeper tread than a drive axle. A truck tyre tread depth is measured in the main grooves across the tread, and the driver or operator is responsible for keeping every tyre above its minimum. This page explains the minimums, where the grooves are checked, and how to read the result.
Minimums by axle position
The steer axle carries the highest tread minimum on a truck, because those tyres do the steering and braking guidance. A drive axle tread rule allows a shallower figure, since torque and load transfer behave differently there. Trailer axles follow their own minimum, which can be higher than the drive axle figure. The exact figures depend on the vehicle class and the country of operation, so check the rule that applies to your vehicle.
How tread depth is measured
Tread depth is read in the main circumferential grooves of a commercial vehicle tyre, not in the small sipes or shoulder slots. A tread depth gauge is pressed into the groove at several points around the circumference and across the width. The lowest reading found is the one that counts against the legal minimum. Worn or uneven wear patterns can drop a single groove below the limit while the rest still look fine.
Why groove depth matters
Grooves clear water from under the contact patch, and a shallow groove loses that ability on a wet surface. A commercial vehicle tyre with tread at the legal limit is legal but close to the end of its useful life on a wet road. Aquaplaning risk rises as depth falls, and a loaded truck needs more distance to stop. Replace a tyre before the grooves reach the minimum rather than after.
Questions about truck tyre tread minimums
What is the legal tyre tread depth limit for an HGV?
The legal HGV tyre tread minimum is set per axle, with the steer axle requiring the deepest tread of the vehicle. A figure of 4/32 inch is often quoted for steering axles, while other axles carry a lower minimum in many rule sets. The exact limit depends on the vehicle class and the country, so confirm the rule for your operation.
Is the legal tire tread depth for commercial vehicles the same on every axle?
No, legal tire tread depth for commercial vehicles differs between the steer axle and the drive axles. Steering tyres must hold a deeper minimum because they guide the vehicle, and drive tyres follow a lower figure. Trailer tyres often have their own minimum as well. Treat each axle group on its own during an inspection.
What is the legal tire tread depth for a semi truck?
The legal tire tread depth for a semi truck follows the same axle-based pattern as other heavy vehicles. The steer axle holds the highest minimum, and the drive and trailer axles use a lower one. Figures vary by country and vehicle category, so read the local rule before you judge a tyre. Measure the main grooves rather than the tread surface.
How do I check my truck tyres during a commercial vehicle tyre inspection?
A commercial vehicle tyre inspection checks each main groove with a depth gauge at several points around the tyre. The lowest reading in any groove is compared with the minimum for that axle. Look for uneven wear, cuts and exposed cords at the same time, since these affect fitness beyond depth. A trained technician should confirm any tyre that sits close to the limit.