Used 20-Inch Tire Sizes
Learn how used 20-inch tire sizes are written on the sidewall, how metric sizes map to a 20-inch rim, and which load index and speed rating to check.
Contents
- Reading the sidewall size numbers
- Metric sizes that fit a 20-inch rim
- What inch sizes and load index mean
- Questions about used 20-inch tire sizes
- Where do I find the size of a used 20-inch tire?
- What does the 20 mean in a tire size?
- Can a metric tire size be converted to an inch size?
- What load index and speed rating should a used tire have?
Used 20-inch tire sizes are the numbers molded on a tire that fits a 20-inch rim, and they tell you the width, the sidewall height and the rim diameter before you buy. A used tire carries the same markings as a new one, so the size on the sidewall is the place to start. The page explains each number, the metric and inch ways of writing a size, and the load and speed figures that go with it.
Reading the sidewall size numbers
A metric size such as 275/45R20 packs three facts into one line on the sidewall. The first number is the tire width in millimeters, and the second is the sidewall height as a percentage of that width. The 20 after the letter R is the 20-inch rim diameter the tire mounts on. Read the whole line before you compare two used tires.
Metric sizes that fit a 20-inch rim
A 20-inch tire size in metric form always ends with the rim diameter of 20. The width and sidewall figures change between sizes, so a 245/45R20 and a 275/40R20 both fit the same rim but sit differently on it. Tire overall diameter follows from those two figures, not from the rim number alone. Check the door jamb or the owner's manual for the size the vehicle was built for.
What inch sizes and load index mean
Inch sizes appear on some tires as a diameter figure, such as 35x12.50R20, where the first number is the tire overall diameter in inches. Metric and inch size conversion is not a straight swap, because a metric tire states width and sidewall ratio instead of total height. The load index is a code for the weight the tire carries, and the speed rating is a letter for its top speed. Match both to the vehicle's requirements before fitting a used tire.
Questions about used 20-inch tire sizes
Where do I find the size of a used 20-inch tire?
The size of a used 20-inch tire is molded on its sidewall as a line such as 275/45R20. Look for the number ending in R20, which confirms the 20-inch rim diameter. Inspect the same area for the load index, the speed rating and any damage marks. A worn or unreadable sidewall makes the size hard to confirm.
What does the 20 mean in a tire size?
The 20 in a tire size names the 20-inch rim diameter the tire is built to mount on. A tire marked with 20 at the end of the size line fits a wheel with a 20-inch bead seat. The number says nothing about the tire's outer height, which comes from the width and sidewall figures. Always confirm the rim diameter before buying a used tire.
Can a metric tire size be converted to an inch size?
A metric tire size can be converted to an inch size by calculating the tire overall diameter from the width and sidewall ratio. Multiply the width by the sidewall percentage, double that figure and add the rim diameter in millimeters. The result, divided to inches, gives the height in inch terms. A conversion is close but not exact, so measure the tire if the fit is tight.
What load index and speed rating should a used tire have?
The load index and speed rating of a used tire should meet or exceed the figures the vehicle maker specifies. The load index is a code for carrying capacity, and the speed rating is a letter for the maximum speed the tire is built for. A lower figure than the vehicle requires is not a safe substitute. Check both codes on the sidewall against the vehicle's placard.