Tire Width Calculator in Inches
Convert tire section width from millimeters to inches with a simple formula, read the sidewall markings, and check the width in both units.
Contents
- The tire width formula in steps
- What the sidewall numbers say
- Section width in both units
- Questions about tire width in inches
- How do I convert tire width to inches?
- What is tire section width in inches?
- Is the first number on the sidewall the tire width?
- Does the actual tire width match the calculated width?
A tire width calculator in inches converts the section width stamped on the sidewall from millimeters to inches by dividing by 25.4. The width number in a tire size such as 225/45R17 is the section width in millimeters, measured across the widest part of the inflated tire. Dividing that number by 25.4 gives the tire width in inches, which is the figure you compare against rim and clearance dimensions.
The tire width formula in steps
A tire width calculation takes the first number of the size and divides it by 25.4, the number of millimeters in one inch. For a 225/45R17 tire, 225 divided by 25.4 gives about 8.86 inches of section width. The result describes the tire carcass as mounted and inflated on its measuring rim, not the tread face. Round the figure to two decimals when you compare tires, because the sidewall number itself is a nominal value.
What the sidewall numbers say
Tire width markings appear as the first group of digits in the size string, before the slash. The number after the slash is the aspect ratio, a percentage of the section width that gives sidewall height. In 225/45R17, the 45 means the sidewall height is 45 percent of 225 millimeters, not a width figure. Reading the sidewall width this way keeps the width and the height apart when you calculate.
Section width in both units
Tire section width in millimeters and inches describes the same measurement, so one conversion serves both. The millimeter value is the size code printed on the tire, while the inch value is easier to compare with wheel width and fender gaps. Section width in inches also helps when a spec sheet lists rim width in inches and tire data in millimeters. A tire width measurement taken with a tape on the vehicle can differ from the nominal figure because of rim width and load.
Questions about tire width in inches
How do I convert tire width to inches?
Tire width conversion divides the millimeter section width by 25.4 to get inches. Take the first number of the size, such as 205 in 205/55R16, and divide it by 25.4 for about 8.07 inches. Use the same divisor for every tire, since the inch is fixed at 25.4 millimeters. The result is the nominal section width, not a measurement of the tread.
What is tire section width in inches?
Tire section width in inches is the widest span of the inflated tire from sidewall to sidewall, expressed in inches. It comes from the first number of the size code after millimeter to inch conversion. The figure assumes the tire sits on its specified measuring rim at the rated inflation pressure. A different rim width shifts the measured width away from the nominal value.
Is the first number on the sidewall the tire width?
Yes, the first number of a tire size is the section width in millimeters, so it is the number you convert for width. In 235/40R18 the 235 is the section width, the 40 is the aspect ratio, and the 18 is the rim diameter in inches. The sidewall carries the width in millimeters only, even when the rim diameter is already in inches. Convert the width with the 25.4 divisor to compare it with inch dimensions.
Does the actual tire width match the calculated width?
No, actual tire width can differ from the calculated figure because the size code is nominal. Rim width, inflation pressure and tire construction all change where the sidewalls sit when the tire is mounted. A wider rim tends to pull the sidewalls outward and add measured width. Use the calculated width for comparison and measure the mounted tire when clearance is tight.