Tire Section Width vs Tread Width
Learn how tire section width differs from tread width, where each is measured, and how the two numbers relate when you compare tires for fitment.
Contents
Tire section width vs tread width comes down to where the tape measure sits: section width is the widest point across the inflated tire, while tread width covers only the rubber that meets the road. The sidewall numbers give you section width directly, but tread width is a separate figure you have to look up. Knowing both helps you judge how a tire sits on a wheel and how much contact patch it puts down.
Reading section width from the sidewall
Tire section width is the nominal size printed on the sidewall, measured across the widest part of the inflated casing. In a size like 225/45R17, the first number is that cross section width in millimeters. The figure assumes the tire is mounted on its specified measuring rim and inflated to a set pressure. Change the rim width and the real section width shifts, so the sidewall number is a reference point rather than an exact tape reading.
Measuring tread width on the ground
Tread width is the distance across the tread face, from one shoulder edge to the other. Tire makers publish this separately because it is not written into the size code. Measuring tire width at the tread gives you the footprint width that carries load and grips the surface. A wider tread face puts more rubber down, while a narrow one cuts through water and snow more easily.
The tread to section width ratio
The tire tread width to section width ratio compares the contact face with the widest point of the casing. Tires of the same nominal size can differ in this ratio because shoulder design and sidewall shape vary between models. A higher ratio means the tread runs closer to the widest part of the tire. Use the ratio for tire width comparison when you want to know how much of the casing actually reaches the road.
Questions about tire width
What is tire section width?
Tire section width is the measurement across the widest part of an inflated tire, from sidewall to sidewall. It appears as the first number in the size code, given in millimeters. The value is taken on a specified rim at a set pressure, so it describes the casing rather than the tread. Cross section width and section width mean the same thing.
Is tire width the same as tread width?
No, tire width and tread width are not the same measurement. Tire width in a size code refers to section width, the widest point of the sidewalls. Tread width is narrower and covers only the tread face that touches the road. The gap between the two comes from the shoulder and sidewall shape.
How do I find the tread width size?
Tread width size is not printed in the sidewall size code, so you find it in the tire maker's published specifications. Look up the exact model and size and read the tread width figure there. Comparing that number across models shows the real tread width difference. Section width alone cannot tell you the tread width.
What does the tread width to section width ratio tell me?
The tread width to section width ratio shows how much of the tire's widest span is taken up by the tread face. A tire with a high ratio carries its tread close to the widest point of the casing. This ratio helps in tire width comparison between models of the same nominal size. It describes shape, not how much grip a tire delivers.