Measuring a Spare Trailer Tire
Learn how to measure a spare trailer tire with a tape measure, read the sidewall size code and compare diameter and width to fit a spare tire mount.
Contents
- Read the sidewall size code first
- Measure the spare tire diameter
- Check width and mounting clearance
- Questions About Measuring Trailer Spare Tires
- How do I measure a spare trailer tire?
- Is the tire width the same as the tread width?
- Can I measure a spare tire without taking it off the mount?
- Does the wheel diameter belong in the tire measurement?
Measuring a spare trailer tire means reading the sidewall size code first and then checking the tire with a tape measure. The code gives the width, the aspect ratio and the wheel diameter in one line. A direct measurement of the mounted spare confirms the diameter across the tread and the width across the sidewall. Both results help you match a replacement tire or check that a spare tire mount has room.
Read the sidewall size code first
The sidewall size code is the fastest way to learn the size of a spare trailer tire. A code such as ST205/75R15 gives the section width in millimeters, the aspect ratio and the wheel diameter in inches. The letter ST marks a special trailer tire built for towing duty. Confirm the code with a tape measure before you order a replacement.
Measure the spare tire diameter
Spare tire diameter is measured across the tread from the ground to the top of the tire on a mounted wheel. Lay a tape measure straight through the center and read the height at the tread surface. A free tire stands upright against a wall so the tape crosses the middle without sagging. Record the number next to the sidewall code so the two can be compared.
Check width and mounting clearance
Tire width measurement starts at the outer edge of one sidewall and ends at the outer edge of the other. Place the tape across the tire at its widest point, not at the tread face. A spare tire mount holds the wheel by the hub or the bolt holes and needs clearance around this width. Check the free space around the mount before you tighten the tire down.
Questions About Measuring Trailer Spare Tires
How do I measure a spare trailer tire?
Measuring a spare trailer tire takes a tape measure and the sidewall size code. Read the code for the listed width, aspect ratio and wheel diameter, then measure the tread-to-tread height and the sidewall-to-sidewall width. Write the three numbers down and compare them to the code.
Is the tire width the same as the tread width?
Tire width measurement is not the tread width. The sidewall code and a tape measure both report the section width, which spans the outer faces of the sidewalls at the widest point. Tread width covers only the part that touches the road and is smaller than the section width.
Can I measure a spare tire without taking it off the mount?
A mounted spare trailer tire can be measured in place when the frame leaves room for a tape measure. Measure the diameter from the ground to the top of the tread and read the sidewall code for the width. Take the tire off the spare tire mount when the frame blocks the tape or the reading looks unclear.
Does the wheel diameter belong in the tire measurement?
The wheel diameter is a separate number from the tire dimensions. The last figure in the sidewall size code states the rim size in inches, so a 15 there means a 15 inch trailer spare wheel. Measure the tire itself for overall height and width, and use the code for the rim size.