How to Use Tire Mounting Paste

A step-by-step look at how to use tire mounting paste: where to apply the lubricant on the bead and rim, how much to use, and what to avoid.

3 min read1 views
— · 0 votes
Contents
  1. Clean the bead and rim surface
  2. Apply paste to the bead
  3. Seat the bead and clean up
  4. Tire mounting paste questions
  5. Do I put mounting paste on the tire bead or the rim?
  6. How much tire mounting paste should I use?
  7. Can I use soapy water instead of tire mounting paste?
  8. Does tire mounting paste need to be removed after mounting?

How to use tire mounting paste is a question of placing a slick lubricant on the right surfaces before the tire goes onto the wheel. Mounting paste, also called tire bead lubricant, lets the tire bead slide over the rim flange and seat without tearing or catching. The method is simple, but the surfaces you coat and the amount you apply decide whether the bead seats cleanly.

Clean the bead and rim surface

Tire mounting paste works only when the bead and rim surface are free of dirt, rust and old lubricant. Wipe the rim flange and the inside of the tire bead with a clean cloth before you open the paste. A gritty surface traps debris under the paste and can stop the bead from seating evenly. Check that the wheel is dry so the paste stays where you put it.

Apply paste to the bead

Applying mounting paste to the bead means coating the full circumference, not just one spot. Load a brush or applicator and run a thin, even film around the tire bead on both sides. A light coat lets the rubber slip over the rim flange during mounting. Too much paste can run onto the tread or the brake area, so keep it on the bead.

Seat the bead and clean up

Mounting lubricant application on the rim flange helps the bead slide up and lock into place as the tire inflates. Coat the flange lightly, then mount the tire and inflate it according to the wheel and tire maker's instructions. Wipe away excess paste from the rim and sidewall once the bead is seated. Work carefully, because inflating a tire to seat a bead can be dangerous and belongs with trained tire service staff.

Tire mounting paste questions

Do I put mounting paste on the tire bead or the rim?

Mounting paste goes on both the tire bead and the rim flange, since each surface slides against the other. A thin film on the full bead circumference and a light coat on the flange give the best slip during mounting. Keep the paste off the tread and away from the brake parts. Wipe the surfaces clean first so the paste contacts rubber and metal directly.

How much tire mounting paste should I use?

A thin, even film around the bead is enough tire mounting paste for a normal mount. The paste is a lubricant, not a sealant, so a heavy layer adds no benefit and can spread onto the tread. Reload the brush in small amounts and work around the full circumference. Wipe off any excess after the bead seats.

Can I use soapy water instead of tire mounting paste?

Soapy water can help a bead slide, but tire mounting paste is made to stay in place on the bead and rim surface. Household soap leaves a residue that can affect how the bead sits and hold moisture against the metal. Paste is the product intended for the job. Use the lubricant the tire and wheel makers specify.

Does tire mounting paste need to be removed after mounting?

Tire mounting paste should be wiped off the rim and sidewall once the bead is seated. Leftover paste can attract dirt and make the wheel look messy over time. A clean cloth takes off the film before it dries. Check the bead area after inflation and remove any paste you can reach.

Read next

Latest articles