How to Use a Tire Tread Gauge

Learn how to use a tire tread gauge step by step: zero the tool, seat the probe in a groove, read the depth, and check the tread wear indicator.

3 min read4 viewsHow to Use a Tire Tread Gauge
— · 0 votes
Contents
  1. Zero the gauge before measuring
  2. Seat the probe in the measuring groove
  3. Compare the reading with the wear indicator
  4. Questions about tire tread gauges
  5. How do I use a tire tread gauge tool?
  6. How does a tread depth gauge compare with the penny test?
  7. Where do I measure tread depth on a tire?
  8. What does a tread wear indicator show me?

A tire tread gauge is a small measuring tool that shows how much rubber remains between the top of a tread block and the bottom of its groove. The steps below explain how to use the gauge, where to place its probe, and how to interpret the reading against the 2/32 inch limit. The same page covers how a tread depth reading compares with the penny test and what the tread wear indicator tells you.

Zero the gauge before measuring

A tire tread gauge must start from zero so the scale reflects the groove depth only. Push the probe fully into the body of the tool and set the collar or sliding scale to the zero mark. Check the zero point again after each tire, because the probe can shift in its sleeve. A gauge that does not return to zero gives a false tread depth reading on every groove you measure.

Seat the probe in the measuring groove

Place the gauge perpendicular to the tread so the probe drops straight into a measuring groove. Push the collar flat against the tread block on both sides and let the probe bottom out on the groove floor. Read the scale where the collar stops, then repeat on two more grooves across the tire. Angling the tool or resting it on a stone in the groove gives a shallow reading that does not match the true depth.

Compare the reading with the wear indicator

A tread wear indicator is a raised bar inside the main grooves that marks the 2/32 inch depth limit. Slide the gauge probe beside the bar to confirm how much tread remains above it. When the tread surface sits level with the indicator, the tire has reached the limit and needs replacement. Check each main groove around the tire, since inner and outer edges can wear at different rates.

Questions about tire tread gauges

How do I use a tire tread gauge tool?

A tire tread gauge tool works by trapping a sliding probe between the tread block and the groove floor. Rest the collar on the tread, push the probe down, and read the depth on the scale. Take several readings per tire and compare them, because one groove does not describe the whole tread.

How does a tread depth gauge compare with the penny test?

A tread depth gauge gives a numbered depth, while the penny test only shows whether Lincoln's head is covered. The penny test is a rough check that cannot report a value in 32nds of an inch. A gauge is the better choice when you need to track tread depth over time or measure near the 2/32 inch limit.

Where do I measure tread depth on a tire?

Measure tread depth in the wide circumferential grooves that run around the tire, not in the small slots at the block edges. Take readings at the inner, center and outer parts of the tread. Edge grooves often wear faster, so include them in every check.

What does a tread wear indicator show me?

A tread wear indicator sits inside the main grooves and rises to the 2/32 inch level. Tread that sits even with the indicator has reached the legal wear limit in many places. Use a gauge beside the indicator to see exactly how much depth is left.

Read next

Latest articles