How to Calculate Process Capability Index (Cp and Cpk) with an Example
Learn the Cp and Cpk formulas, how to find the process mean and sigma from tire dimension data, and follow a step by step example to read the capability ratio.
Contents
This page shows how to calculate the process capability index (Cp and Cpk) using a short worked example. It gives the Cp formula and the Cpk formula in plain terms, shows how the process mean, standard deviation (sigma), USL and LSL fit together, and then applies them to tire dimension measurement data.
The Cp formula and its limit
Cp compares the width of a tolerance to the spread of a process. Subtract the lower specification limit (LSL) from the upper specification limit (USL), then divide by six sigma. The result tells you how much room the process spread has inside the specification, but only if the process mean sits at the tolerance center. A Cp value above one means the spread is narrower than the tolerance.
The Cpk formula adds centering
Cpk measures capability when the process mean is off center, which is the realistic case for tire dimension measurement data. Find the distance from the mean to the nearer specification limit, then divide by three sigma. Use the USL minus the mean or the mean minus the LSL, whichever is smaller. Cpk is never higher than Cp, and the gap between them shows how far the process has drifted.
A worked example step by step
Take a tire dimension with a USL of 612 and an LSL of 608, so the tolerance is four units wide. Suppose the measured process mean is 610.5 and sigma is 0.5. Cp is four divided by six times 0.5, which equals 1.33. For Cpk, the nearer limit is the USL, so 612 minus 610.5 is 1.5, and 1.5 divided by 1.5 gives Cpk equal to 1.0.
Process Capability Index Questions
What is the process capability index Cp?
The process capability index Cp is a ratio of tolerance width to process spread. Cp divides the USL minus the LSL by six sigma and assumes the process mean is centered. A higher Cp means the spread fits more easily inside the tolerance.
How do I calculate the Cpk index?
You calculate Cpk from the distance between the process mean and the nearer specification limit. Subtract the mean from the USL, or the mean from the LSL, keep the smaller value, and divide by three sigma. This shows capability with the real off center mean included.
What is the process capability index formula in short?
The Cp formula is USL minus LSL divided by six sigma. The Cpk formula is the smaller of USL minus mean or mean minus LSL, divided by three sigma. Both need a stable process, a sigma estimate and clear specification limits before you trust the number.
How can I use capability for tire measurements?
Tire dimension capability works the same way as any capability study, with the tire dimension data supplying the mean and sigma. Set the USL and LSL from the drawing, measure a sample, and compare Cpk against the requirement. A low Cpk points to spread or drift that the workshop must correct.