Ford F-150 Tire Pressure for Towing
How to set Ford F-150 tire pressure for towing: read the door placard, respect loaded axle weights, match tire specs, and use load-inflation tables.
Contents
- Read the placard before you tow
- Weigh the loaded axles
- Match replacement tires to the truck
- Ford F-150 towing tire pressure questions
- What tire pressure should I run when towing with an F-150?
- Should I inflate the rear tires more than the front for towing?
- Does the number on the tire sidewall set my towing pressure?
- Can I use the placard pressure with a different tire size?
Ford F-150 tire pressure for towing starts with the tire placard on the driver door jamb, not with the number molded on the sidewall. The placard gives the cold inflation pressure the truck was built around for its rated loads. Towing adds weight on the rear axle, so the pressure you run should follow the loaded axle weights and the tire you actually have fitted. This page explains how to read those figures and where a load-inflation table fits in.
Read the placard before you tow
The tire placard on a Ford F-150 lists the recommended cold tire pressure for the front and rear axles as the truck left the factory. Cold means the tires have sat without driving and have not built heat. Check pressure before a trip and never bleed air from a hot tire to match the placard. The placard figure applies to the original tire size and load range, so a replacement tire changes what you should run.
Weigh the loaded axles
Loaded axle weights tell you what each axle actually carries once the trailer, tongue weight and cargo are aboard. A truck can sit within its gross weight rating while one axle is overloaded, which is why axle figures matter. Weigh the truck and trailer at a scale with the load in place. Compare each axle reading with the tire load capacity at the pressure you plan to use.
Match replacement tires to the truck
Original and replacement tire specifications decide whether the placard pressure still suits your Ford F-150. A replacement tire with a different size or load range carries a different load at a given pressure. Load-inflation tables published by the tire maker show the pressure needed to carry a stated load. Use the table for your exact tire, and fit a tire whose capacity covers your loaded axle weight.
Ford F-150 towing tire pressure questions
What tire pressure should I run when towing with an F-150?
Ford F-150 towing tire pressure follows the door placard first, then the loaded axle weights. Start with the placard cold pressures for the front and rear axles. If a scale shows a heavier rear axle, raise rear pressure to the level your tire's load-inflation table gives for that load. Stay within the maximum pressure molded on the sidewall.
Should I inflate the rear tires more than the front for towing?
Rear tires on a towing Ford F-150 often need more pressure because the trailer tongue adds load at the back. The placard may already list a higher rear figure than the front. Confirm with loaded axle weights rather than guessing. Set each axle to the pressure its tire needs for the weight it carries.
Does the number on the tire sidewall set my towing pressure?
The sidewall number on a Ford F-150 tire is the maximum cold pressure the tire can hold, not the towing recommendation. The tire placard gives the pressure for the truck's rated loads. Use the sidewall figure as a ceiling and the placard or load table as your setting. Never exceed the sidewall maximum.
Can I use the placard pressure with a different tire size?
The Ford F-150 placard pressure is tied to the original tire specifications, so a different size or load range can change the right figure. Check the replacement tire's load-inflation table for the pressure that carries your loaded axle weight. Make sure the new tire's capacity meets or exceeds the original. Have a tire specialist confirm the match before towing.