Creating Feature Control Frames in NX

Learn how to create a feature control frame in Siemens NX, place the GD&T annotation on a drawing, and read the tolerance it defines for a tire or wheel part.

3 min read0 viewsCreating Feature Control Frames in NX
— · 0 votes
Contents
  1. Where the feature control frame tool sits
  2. Setting symbol, tolerance, and datums
  3. Placement and attachment to geometry
  4. Feature control frame questions in NX
  5. What is a feature control frame in NX?
  6. How do I place a feature control frame on a drawing?
  7. Does a feature control frame need a datum reference?
  8. Where does the datum feature symbol go relative to the frame?

Creating feature control frames in NX means adding a GD&T annotation that states the tolerance zone for a feature, such as a tire's mounting face or a wheel's bolt circle. The frame combines a geometric symbol, a tolerance value, and datum references in one boxed callout. This page explains where the tool sits, how placement works, and how to read the result.

Where the feature control frame tool sits

A feature control frame lives in the PMI annotation tools of Siemens NX, alongside the datum feature symbol and other GD&T annotation. You open the frame command from the product and manufacturing information toolbar or the annotations menu. The dialog asks for a geometric characteristic symbol, a tolerance value, and any datum references before placement begins. Choosing the symbol first keeps the rest of the dialog focused on the fields that matter.

Setting symbol, tolerance, and datums

The frame reads left to right, starting with the geometric characteristic symbol for flatness, position, runout, or another control. The tolerance zone follows the symbol, with a diameter symbol when the zone is cylindrical. Datum references fill the remaining compartments in the order the design intends. Each datum letter in the frame must match a datum feature symbol attached to a real surface of the part.

Placement and attachment to geometry

Feature control frame placement decides what the annotation points at, so attach the leader to the controlled feature rather than to empty space. NX can associate the frame with the model so it follows the geometry when the part changes. A frame that points at no feature leaves the tolerance with no clear subject. Check the leader arrow and the datum letters after placement, because a small slip in the view can attach the frame to the wrong edge.

Feature control frame questions in NX

What is a feature control frame in NX?

A feature control frame in NX is a GD&T annotation that gives the geometric tolerance for one feature. The boxed symbol states the control type, the tolerance value, and the datums the tolerance refers to. NX stores it as part of the PMI annotation set on the model or drawing.

How do I place a feature control frame on a drawing?

Placement starts by picking the controlled feature in the view, then dragging the frame to a clear spot with a leader. NX keeps the frame attached to the geometry you picked, so moving the view carries the frame along. Confirm the leader arrow touches the correct surface before you finish the command.

Does a feature control frame need a datum reference?

A feature control frame needs a datum reference only when the control is measured from datums, as with position or runout. Form controls such as flatness stand alone in the frame with no datum letters. Read the design intent first, then fill the datum compartments only where the tolerance depends on them.

Where does the datum feature symbol go relative to the frame?

The datum feature symbol goes on the surface that acts as the reference, not inside the feature control frame. Its letter is what the frame cites in the datum compartments. Every letter used in the frame must have a matching symbol on the model, or the annotation refers to nothing.

Latest articles