# Wheel Offset and Backspacing Explained: Are They the Same?

Wheel offset and backspacing are different measurements of the same wheel geometry. Learn what each number means and how to convert one to the other.

Wheel offset and backspacing are not the same measurement, though both describe where a wheel sits relative to its hub mounting face. Wheel offset is measured from the wheel centerline, while backspacing is measured from the inner wheel edge to the mounting surface. This page explains each term, shows how the two relate, and helps you read the number stamped on a wheel. 

## Wheel offset is measured from centerline 

Wheel offset is the distance from the wheel centerline to the hub mounting face, expressed in millimeters. Positive offset means the mounting face sits outboard of the centerline, toward the street side of the wheel. Negative offset means the mounting face sits inboard of the centerline. Zero offset means the mounting face and the wheel centerline line up exactly. 

## Backspacing is measured from the inner edge 

Backspacing is the distance from the inner wheel edge to the hub mounting surface, measured in inches or millimeters. A wheel with 4.5 inches of backspacing pushes its mounting face 4.5 inches in from the inner lip. Rim backspacing tells you how much room the wheel takes up toward the suspension and brake hardware. This inner wheel clearance matters when you check fitment against struts, control arms and brake calipers. 

## Converting between offset and backspacing 

You can convert one figure to the other if you know the wheel width and the rim lip thickness. Backspacing equals half the wheel width plus the offset, with the lip allowance added for the physical edge. Offset equals backspacing minus half the wheel width, then corrected for that same allowance. A wheel marked with ET offset uses the same millimeter-based positive and negative system as plain offset. 

## Wheel Offset and Backspacing Questions 

### Is backspacing the same as offset? 

No, backspacing and offset are different measurements of wheel geometry. Offset is referenced to the wheel centerline, while backspacing is referenced to the inner wheel edge. The two give related information about mounting position but are not interchangeable numbers. 

### What is rim backspacing? 

Rim backspacing is the distance from the inner wheel edge to the hub mounting face. Rim backspacing describes how far the wheel extends inward toward the suspension. A larger backspacing number moves the wheel body deeper into the wheel well. 

### What does ET offset mean on a wheel? 

ET offset is the offset value stamped on a wheel, measured in millimeters from the wheel centerline. A positive ET number places the mounting face outboard of center, and a negative value places it inboard. The ET figure is the same measure as wheel offset. 

### How does 4.5 backspacing compare to offset? 

A 4.5 backspacing figure converts to an offset only when you also know the wheel width and lip thickness. Half the width plus the offset gives the backspacing with the lip allowance added. Without the width, a 4.5 backspacing number cannot be turned into a single offset figure.
