What to Check After Getting New Tires
A plain checklist for after new tires are fitted: sidewall markings, tire pressure, wheel torque, balance, alignment and the TPMS light, explained step by step.
Contents
- Verify the sidewall markings
- Check pressure and wheel torque
- Read the first drive for balance and alignment
- Questions about the post-installation tire check
- What should I do right after getting new tires on my car?
- Why is my TPMS light on after a tire change?
- Does a shop have to re-check fitment after mounting tires?
- How do I know the tire balance and alignment are right?
What to check after getting new tires comes down to a short walk around the car and a few numbers you can verify yourself. Confirm the sidewall markings match what you paid for, check tire pressure when the tires are cold and have the wheel torque confirmed. Then watch how the car drives, because balance, alignment and the TPMS light show up in the first miles.
Verify the sidewall markings
Sidewall markings verification starts with reading the size, load index and speed rating molded into each tire. These figures should match the tire and wheel fit verification on your paperwork and the original equipment specification. Look for the date code on the sidewall so you know when each tire was made. A mismatch between the printed size and the invoice is worth raising before you leave the shop.
Check pressure and wheel torque
Tire pressure after fitting should be checked when the tires are cold, using the values on the door jamb label or in the owner manual. A shop may inflate tires to a higher pressure for seating the bead, so read the gauge yourself and adjust. Wheel torque deserves a separate check, because lug nut torque holds the wheel to the hub and a loose wheel is dangerous. Ask the technician for the torque figure and have the wheels re-torqued after the first drive, then leave further tightening to a trained specialist.
Read the first drive for balance and alignment
Wheel balance after a tire change shows up as a vibration through the steering wheel or seat at higher road speeds. Tire balance and alignment are separate jobs, and alignment concerns how the wheels point rather than how they spin. A car that pulls to one side or has an off-center steering wheel may need an alignment check. Report any vibration or pull to the shop rather than correcting it by adjusting tire pressure.
Questions about the post-installation tire check
What should I do right after getting new tires on my car?
A post-installation tire check means reading the sidewall markings, checking cold tire pressure and confirming the wheel torque with the shop. Drive gently at first and note any vibration, pull or unusual noise. The TPMS light may stay on briefly after a tire change while the system relearns. Return to the shop if a warning light or a symptom persists.
Why is my TPMS light on after a tire change?
The TPMS light after a tire change often means the sensors have not been reset or a sensor was disturbed during fitting. Tire pressure check after installation comes first, because a low tire can trigger the same warning. Have the shop perform a post-installation tire inspection of the sensors and the relearn procedure. Do not ignore a flashing TPMS light, since it signals a system fault rather than low pressure.
Does a shop have to re-check fitment after mounting tires?
A fitment re-check policy varies by shop, so ask what their re-check after professional tire work includes. A sensible re-check covers tire and wheel fit verification, lug nut torque and cold tire pressure. Many shops invite a return visit after the first drive for exactly this purpose. Get the re-check terms in writing when you collect the car.
How do I know the tire balance and alignment are right?
Wheel balance after a tire change is right when the car runs smoothly at road speed with no shimmy in the wheel or seat. Alignment is right when the car tracks straight and the steering wheel sits centered on a flat road. Tire balance and alignment both need a shop with the correct equipment, so a home check only confirms the symptom. Report any vibration or pull for a proper post-installation tire inspection.