Track Width Measurement on a 1978 Ford Mustang II
How to measure track width on a 1978 Ford Mustang II: find the wheel centerline front and rear, keep both sides level, and read the result correctly.
Contents
- Finding the wheel centerline
- Measuring front and rear separately
- Keeping the reading accurate
- Mustang II Track Width Questions
- What is the track width measurement on a 78 Mustang 2?
- Do I measure track width to the tire edge or the wheel center?
- Is front track width the same as rear track width on a Mustang II?
- What do I need to measure track width at home?
Track width measurement on a 1978 Ford Mustang II means the distance between the centerlines of the two wheels on the same axle, taken at the ground. The front track width and the rear track width are measured separately, because the Mustang II does not share one figure across both axles. The job needs a flat surface, a plumb line and a steady hand more than it needs special tools.
Finding the wheel centerline
The wheel centerline is the imaginary vertical plane through the middle of the tire and the middle of the hub. On a 1978 Ford Mustang II, drop a plumb line from the center of the wheel arch or the hub face to mark that plane on the floor. Do this at each wheel, front and rear, and mark the floor with tape. The centerline is what the measurement uses, not the outer tire face and not the inner rim edge.
Measuring front and rear separately
Front track width and rear track width are two different numbers on a 1978 Ford Mustang II, so measure each axle on its own. Stretch the tape between the two floor marks at the front axle and read the distance, then repeat at the rear axle. Keep the tape parallel to the axle and level with the ground for a true reading. Write down each figure with the axle it belongs to, since vehicle specifications list them as separate values.
Keeping the reading accurate
A track width measurement is only as good as the surface under the car, so work on a flat, level floor. Bounce the corners of the Mustang II to settle the suspension before you mark the centerlines. Measure to the same point on both sides and check each axle twice to catch a slipped tape. If the car sits unevenly, the plumb marks drift and the front and rear figures stop matching the real geometry.
Mustang II Track Width Questions
What is the track width measurement on a 78 Mustang 2?
Track width on a 1978 Ford Mustang II is the distance between the wheel centerlines on one axle, measured at ground level. The front and rear axles have separate figures, so no single number covers the whole car. Measure each axle yourself or check the vehicle specifications for that model year. The value depends on the axle and on the wheel and tire fitted.
Do I measure track width to the tire edge or the wheel center?
Track width is measured to the wheel centerline, not to the outer tire edge. The centerline runs through the middle of the tire and the middle of the hub. Measuring to the tire sidewall gives a wider figure that changes with tire size. Use a plumb line from the hub to place the mark on the floor.
Is front track width the same as rear track width on a Mustang II?
Front track width and rear track width are separate figures on a 1978 Ford Mustang II and should not be assumed equal. Each axle has its own geometry, so measure the front and the rear independently. Record both numbers with their axle labels. Comparing them shows how the car's stance is set up.
What do I need to measure track width at home?
You need a flat, level floor, a tape measure and a plumb line to drop from each wheel center. Tape or chalk marks the centerline points on the floor so the tape has something to read against. A helper keeps the tape straight and level across the axle. Work carefully around a raised car and use proper supports, since a vehicle can fall and injure someone.