Tire Spring Rate and Vertical Stiffness
Learn what tire spring rate and vertical stiffness mean, how load versus deflection is measured, and why sidewall stiffness changes how a tire carries load.
Contents
Tire spring rate and vertical stiffness describe how firmly a tire resists being squashed when load pushes down on it. The spring rate is the change in load divided by the change in deflection, so a stiff tire gains more force for each millimeter it compresses. This page explains those terms, the units used, and what shapes the number, so you can read a tire's vertical behavior with confidence.
Reading load versus deflection
Tire vertical stiffness comes from a load versus deflection test, where a press pushes the tire onto a flat surface. The tester records force at each step of compression and plots the two against each other. A straight part of that curve gives the radial spring rate, while a curved part shows the tire stiffening as it deflects further. That is why one tire needs a stated load range to give a single rate figure.
Units for spring constant values
A tire spring constant appears in newtons per millimeter (N/mm) or pounds per inch (lbs/in). The two units describe the same idea, force needed to compress the tire by one unit of distance. Tire engineers often convert between them when comparing data from different sources. A higher number means a stiffer vertical response, not a heavier tire.
What sets sidewall stiffness
Sidewall stiffness depends on the tire's construction, including the plies, bead area and rubber compound in the sidewall. A shorter sidewall and a larger wheel give less vertical deflection for the same load. Inflation pressure also changes vertical stiffness, and a tire run low loses load capacity as it deflects more. These factors matter to suspension tuning because the tire acts as the first spring in the vehicle.
Questions About Tire Vertical Stiffness
What is a tire spring rate?
A tire spring rate is the load change divided by the deflection change at the contact patch. It tells you how much extra force the tire carries for each added unit of compression. The rate rises as the tire deflects deeper, so the figure applies over a stated load range rather than at every point.
How is tire vertical stiffness measured?
Tire vertical stiffness is measured by pressing a loaded tire against a flat plate and recording force against deflection. The slope of the resulting load versus deflection curve gives the stiffness value. A trained technician runs this test with proper equipment because a wrong setup gives misleading numbers.
What does N/mm mean for a tire?
N/mm means newtons per millimeter, a unit of spring constant that states force per unit of deflection. A tire rated at a higher N/mm value needs more load to compress it by one millimeter. Lbs/in expresses the same stiffness in pounds per inch for readers who use imperial units.
Why does inflation pressure change tire spring rate?
Inflation pressure changes tire spring rate because the air inside supports part of the load and stiffens the carcass. Raising pressure makes the tire deflect less for a given load, while lowering it allows more deflection. Check the pressure the tire maker specifies before judging any stiffness number.