# Tire Rubbing After a Change in Vehicle Load

Why tires rub after you add passengers or cargo, how load compresses the rear suspension, and how to recheck wheel well clearance before you drive.

Tire rubbing after a change in vehicle load happens because the weight of passengers and cargo pushes the body down toward the tires. Adding weight compresses the springs, which lowers the wheel wells and cuts the gap between tire and body. The page explains why the rub appears only when the car is loaded and how to recheck clearance before you drive. 

## How load compresses the rear suspension 

Rear suspension compression is the drop in ride height caused by weight over the rear axle. Springs are rated for a certain load, and extra passengers or cargo push them shorter. As the body sinks, the wheel well moves down over the tire and the gap shrinks. The same tire that cleared the body when empty can then touch it. 

## Spring sag and loaded ride height 

Spring sag is the loss of ride height a spring shows once it carries weight. A tired spring sags more than a fresh one under the same load. This is why a car that cleared its tires for years can start rubbing after one heavy trip. Judge the clearance with the vehicle loaded, since that is the condition that matters. 

## Rechecking clearance after loading 

Rechecking clearance after loading means looking at the tire and body with the weight already in the car. Park on level ground, load the passengers and cargo as you will drive, and inspect the gap at each wheel. Check the tire sidewall and the inner wheel well for fresh marks. If the gap is tight or the tire fouls the body, remove load or have a trained specialist adjust the fitment before driving. 

## Questions About Loaded Tire Rubbing 

### Why does my tire rub only when the car is loaded? 

Tire rubbing under load appears because weight compresses the springs and lowers the body over the tire. With the car empty, the wheel well sits higher and the gap looks fine. Load the car and the wheel well clearance under load shrinks, so the tire can touch the body. Inspect the gap with the weight in place, not empty. 

### Does adding passengers and cargo change tire clearance? 

Passengers and cargo do change tire clearance by pushing the suspension down and reducing the wheel well gap. The effect grows with the weight added and with how far back it sits. A light load may leave room while a full load closes the gap. Recheck the clearance after loading to see the real condition. 

### How do I recheck clearance after loading the car? 

Rechecking clearance after loading means inspecting the gap with the weight already in the vehicle. Park on level ground and load passengers and cargo as for the trip. Look at the gap between tire and body at every wheel and check for fresh rub marks. If the tire fouls the body, reduce the load or have a trained specialist correct the fitment. 

### Can spring sag cause tire rubbing after a load change? 

Spring sag can cause tire rubbing because a sagging spring holds the body lower than it should. The loss of ride height brings the wheel well closer to the tire even before heavy load is added. A load change then closes the remaining gap. Have a trained specialist inspect the springs if the ride height looks low.
