# Tire Pressure Checklist

A tire pressure checklist that covers the door placard, cold inflation, gauges, TPMS and pre-trip pressure checks so you can set the right PSI safely.

A tire pressure checklist is a short set of steps that starts with the door placard and ends with a gauge reading taken on cold tires. This page answers the searches about setting and checking pressure, from the pre-trip inspection to the [tire pressure monitoring](/articles/tire-inflation-monitoring-system-what-it-is-and-how-it-works/) display. It explains why the sidewall number is not the target and how temperature changes what a gauge shows. The steps use a gauge you trust and the PSI the vehicle maker recommends. 

## Start at the door placard 

The recommended PSI for your vehicle is printed on the door placard or the fuel filler lid, not on the tire sidewall. That placard figure is set by the vehicle maker for the load the car carries and how it rides. The large number molded into the sidewall is the tire's maximum at full inflation, not the pressure you should run day to day. Follow the placard value and check the load table if you carry heavy cargo. 

## Why pressure is read cold 

Cold tire pressure means the reading taken before the tire has been driven and warmed by heat from flexing. Driving raises pressure as the tire heats, so a hot reading is higher than the cold one and does not match the placard figure. Tire pressure should be set cold, then checked again when the tires have cooled. If you must add air when hot, expect to recheck after the tires settle. 

## Reading a pre-trip pressure check 

A pre-trip inspection tire pressure check looks at every tire before you move, not just the one that seems low. Remove the valve cap, press the gauge squarely onto the valve stem, and read the number against the placard. A tire that reads low needs air, and a tire that reads high should be let down to spec if it was overfilled. Look for uneven wear and damage at the same time, and have a trained specialist handle a damaged tire. 

## Tire Pressure Checklist Questions 

### Where do I find the recommended PSI for my tires? 

The recommended PSI comes from the door placard or fuel filler lid, not the tire sidewall. The placard states the cold pressure the vehicle maker specifies for normal loads. The sidewall number is the tire's maximum inflation and is not the everyday target. Use the placard figure unless you are following a load table for heavy cargo. 

### How do I do a pre-trip inspection tire pressure check? 

A pre-trip inspection tire pressure check means testing every tire with a gauge before driving off. Check the tires when they are cold, compare each reading to the placard, and add air where a tire is low. Look for cuts, bulges and uneven wear while you are at each wheel. A trained specialist should inspect any tire that shows damage. 

### What does tire pressure monitoring tell me? 

Tire pressure monitoring warns you that a tire has dropped below its set threshold, but it does not replace a gauge. The system is a prompt to stop and check, not a measurement you can use to set pressure. A gauge reading against the placard remains the way to confirm and correct inflation. TPMS sensors can also need service after a tire change. 

### Should I check my tires when they are hot? 

You can check tire pressure when hot, but the reading will be higher than the cold placard value. Hot pressure has risen because the tire heated up, so do not let air out to match the placard at that point. Set the pressure cold, or wait until the tires cool and recheck. Comparing hot readings only shows a tire is losing pressure, not how much air it needs.
