# Tire Dimension Formula: Deriving Tire Dimensions from Sidewall Numbers

Derive tire section width, sidewall height and overall diameter from the sidewall size code, with the formulas, a comparison method and accuracy notes.

The tire dimension formula turns the sidewall size code into three geometric numbers: section width, sidewall height and overall diameter. A metric size such as 205/55R16 gives the nominal section width in millimeters, the aspect ratio as a percentage, and the rim diameter in inches. From those three figures you derive every other dimension with simple multiplication and addition. 

## Reading the size code first 

Every metric [tire size code](/articles/tire-size-markings-width-aspect-ratio-construction-rim-size-material-44540/) carries three values in a fixed order. The first three digits of the tire size are the nominal section width in millimeters, and the two digits after the slash are the aspect ratio percentage. The number after the letter R is the rim diameter in inches, which is the one value not given in millimeters. Read the code left to right before any math, because each formula takes its input from a specific position. 

## Section height and overall diameter 

Sidewall height from aspect ratio is the section width multiplied by the aspect ratio and divided by one hundred. A 205/55 tire has a nominal section width of 205 mm and a sidewall height of about 113 mm. [Overall tire diameter](/articles/tire-diameter-chart-in-inches/) adds two sidewall heights to the rim diameter, so convert the rim to millimeters by multiplying inches by 25.4. Rim diameter plus two sidewalls gives the overall diameter formula used in every size comparison. 

## Converting and comparing sizes 

A millimeter to inch conversion divides by 25.4, which lets you place a metric size beside an inch-based one. Comparing two tire sizes means running the same formulas on each code and subtracting the results for diameter and width. The [tire dimension comparison](/articles/tire-dimension-comparison-from-sidewall-markings/) formula exposes differences that the size codes alone hide, such as a wider tire with a shorter sidewall. Keep each result labeled with its unit so a mixed comparison stays readable. 

## Tire Dimension Formula Questions 

### How do I calculate tire dimensions from the sidewall numbers? 

Tire dimensions come from three steps applied to the sidewall numbers in order. Take the first three digits as section width in millimeters, multiply by the aspect ratio percentage for sidewall height, and add twice that height to the rim diameter in millimeters. The result is the nominal overall diameter, which you can convert to inches by dividing by 25.4. 

### What is the formula for tire diameter from the sidewall? 

Tire diameter from the sidewall follows one equation: rim diameter in inches times 25.4, plus two times the section width times the aspect ratio divided by one hundred. That gives the overall diameter in millimeters. The factor of two matters because the diameter crosses the sidewall at the top and at the bottom of the wheel. 

### How do I calculate tire width from the markings? 

Tire width comes directly from the first three digits of the size code, which state the nominal section width in millimeters. No multiplication is needed for the width itself, though you convert it to inches by dividing by 25.4. The measured section width can differ slightly from this nominal figure because of rim width and measurement tolerance. 

### How accurate is a derived tire dimension? 

A derived tire dimension is a nominal figure, not a measured one, so treat it as an approximation. The published section width assumes a specific measuring rim, and the actual tire can vary within a manufacturing tolerance. Rounding error in derived dimensions grows when you convert units, so keep the full value until the final step. For fitment decisions that affect clearance or safety, confirm against the tire maker's published specifications.
