Tire Clearance at Full Steering Lock
Learn how to measure tire clearance at full steering lock, where rubbing happens, and how offset, scrub radius, and steering rack travel affect fitment.
Contents
- Where rub shows up at full turn
- Measuring clearance at maximum steering angle
- How offset and scrub radius shift the gap
- Questions About Tire Clearance at Full Lock
- What does tire clearance at full steering lock mean?
- Why does my tire rub only when I turn the wheel all the way?
- How do I measure wheel clearance at full lock?
- Does wheel offset affect clearance when turning?
Tire clearance at full steering lock is the free space between each tire and the parts around it when the steering wheel is turned all the way to its stop. Clearance can shrink sharply at that point, even when the tire sits fine with the wheels straight. This page explains where contact happens, how to measure at maximum steering angle, and which geometry settings change the result.
Where rub shows up at full turn
Tire rub at full turn appears where the steering angle swings the tire inward toward the inner fender, liner, or suspension arm. The inner sidewall and shoulder of the front tire move closest to those parts as the wheel pivots. On the outer side, the tire corner can approach the fender lip or bumper edge. Check both sides, because the steering rack moves the wheels through different arcs.
Measuring clearance at maximum steering angle
Measuring clearance at maximum steering angle means turning the wheels to the stop and checking the gaps on a level surface. Use a thin gauge or your fingers to test the space between the tire and the nearest component, front and rear of the tire. Repeat on the other side and with the suspension loaded as it sits on the ground. Measure again with the steering held at the stop, since the gap can change as the tire flexes.
How offset and scrub radius shift the gap
Wheel offset and scrub radius decide where the tire sits relative to the steering pivot, which changes the room it has when turned. A wheel that pushes the tire outward can move the outer shoulder closer to the fender lip. A wheel that pulls it inward can bring the inner sidewall near the suspension and liner instead. Steering rack travel sets how far the wheel turns, and a wider steering angle uses more of the available space.
Questions About Tire Clearance at Full Lock
What does tire clearance at full steering lock mean?
Tire clearance at full steering lock is the gap between the tire and nearby parts when the steering reaches its maximum angle. This gap is smaller than the gap with the wheels straight in many setups. The clearance depends on tire width, wheel offset, and the steering angle the rack allows.
Why does my tire rub only when I turn the wheel all the way?
Tire rub at full turn happens because the steering angle swings the tire inward and outward past its straight-ahead position. The inner sidewall moves toward the inner fender, liner, and suspension, while the outer shoulder nears the fender lip. A small gap with the wheels straight can close completely at the stop.
How do I measure wheel clearance at full lock?
Wheel clearance at full lock is measured by turning the steering to the stop and checking the gap to the nearest part. Use a thin gauge between the tire and the liner, arm, or fender on both sides. Measure with the vehicle resting on the ground so the suspension sits at its normal height.
Does wheel offset affect clearance when turning?
Wheel offset does affect clearance when turning because it sets how far the tire sits from the steering pivot. Offset also changes scrub radius, the distance between the tire contact point and the steering axis. Both settings move the tire's swing path and can bring the sidewall or shoulder closer to nearby parts.