# Shuttle Van Tire Checks

How to check shuttle van tires: measure tread depth, set tire pressure, inspect sidewalls, read tire age, and match dimensions across axles for group vehicles.

Shuttle van tire checks are the walk-around routine that confirms every tire on a group vehicle holds safe tread depth, correct tire pressure, a sound sidewall and a matching size across each axle. A driver or technician performs the checks with a gauge and a tread tool before the vehicle carries passengers. Each result is recorded against the position of the tire so wear trends show up early. 

## Measuring tread depth correctly 

Tread depth on a shuttle van tire is measured in the main grooves at several points around the circumference. A tread depth gauge gives a reading in fractions of an inch or in millimeters, and the wear indicator bars inside the grooves show the limit. A tire worn to the indicator bar needs replacement before the van returns to service. Measure each groove rather than one spot, because uneven wear points to alignment or inflation trouble. 

## Setting pressure for a loaded van 

Tire pressure on a shuttle van is set cold, before the vehicle has run far enough to heat the tires. The placard on the door jamb states the pressure for the van at its rated load, and that figure overrides any number molded on the sidewall. Check pressure with a calibrated gauge on every tire, including the spare if the van carries one. A tire that keeps losing pressure needs a leak inspection before the next trip. 

## Sidewall inspection and tire age 

A sidewall inspection looks for cuts, bulges, cracking and embedded objects that a tread check misses. The DOT code molded into the sidewall ends with four digits that give the week and year of manufacture, which is how tire age is read. Rubber hardens with age, so a tire can look sound and still be past its useful service life. Replace any tire with a bulge or a deep cut through the sidewall rather than repairing it. 

## Shuttle Van Tire Check Questions 

### How do I match tire dimensions across the axles of a shuttle van? 

Tire dimensions must match across an axle, so both tires on the front share one size and both on the rear share another. The sidewall markings give section width, aspect ratio and rim diameter, and all three must agree on a driven axle. Mixing sizes across an axle strains the differential and changes handling under load. Check the markings on each tire before the van goes into service. 

### What does a shuttle tire check cover besides tread and pressure? 

A shuttle tire check also covers sidewall condition, valve stems, wheel torque and the spare. Inspect each sidewall for cuts and bulges and confirm the valve cap seals the stem. Tire age belongs in the check, because a tire stored for years may fail despite full tread. Record every finding against the wheel position so repeat problems stand out. 

### How often should shuttle van tires be checked? 

Shuttle van tires are checked before each trip and inspected in depth at a set service interval. Pressure and a visual walk-around suit the pre-trip check, while tread depth and tire age readings fit the deeper inspection. The right interval depends on distance covered, load carried and road conditions, so set it for the route. A tire showing damage comes out of service at once regardless of the schedule. 

### Can a damaged sidewall on a shuttle tire be repaired? 

A sidewall cut or bulge on a shuttle tire cannot be repaired safely and the tire is replaced. Sidewall rubber carries the load and flexes constantly, so a patch does not restore its strength. A trained tire technician should confirm the damage and mount the replacement. Tread punctures in the repairable zone may take a proper plug and patch from a specialist.
