# Run-Flat Tire Sidewall Damage: Bubbles, Bulges and Blowouts

Learn what a bubble, bulge or blowout on a run-flat tire sidewall means, why a reinforced sidewall fails, and when the tire has to be replaced.

Run-flat tire sidewall damage shows up as a bubble, a bulge or a sudden blowout, and each one means the reinforced sidewall has lost its structure. A run-flat tire carries its load on a stiffened sidewall, so any break in that wall is a safety issue rather than a cosmetic flaw. The page explains what each defect looks like, how a technician inspects the sidewall, and when the tire must be replaced. 

## What a sidewall bubble means 

A sidewall bubble is a pocket of air or a split cord layer trapped under the outer rubber of the tire. The bubble forms where the sidewall was pinched against the rim, so the inner liner and the reinforcing cords separate from the casing. A run-flat sidewall bubble grows as the weakened wall flexes under load, and the tire cannot be repaired once separation starts. A bubble on any sidewall calls for replacement, not a patch. 

## Bulge versus bubble 

A tire sidewall bulge is a soft outward swelling of the whole wall, while a bubble is a sharper raised pocket in one spot. A bulging sidewall often follows a hard impact or a long run at low pressure that fatigues the reinforced sidewall of a run-flat. Press a gloved hand along the wall and look for a ridge or a dip that breaks the smooth curve. A bulge that stays visible with the tire off the ground points to cord damage inside the wall. 

## How a blowout happens 

A run-flat tire sidewall blowout is the final stage of damage that was already there. Heat builds in a flexing, weakened sidewall until the cords give way and the wall bursts, which can happen at speed. A sidewall separation, where the rubber lifts away from the casing, is the warning that comes before a blowout. A tire with a bubble, a bulge or a separation should be taken off the vehicle before it reaches that point. 

## Questions about run-flat sidewall damage 

### Can a run-flat tire with a sidewall bubble be repaired? 

No, a run-flat tire with a sidewall bubble cannot be repaired. The bubble means the inner liner and cords have separated inside the reinforced sidewall, and a patch cannot restore that structure. A tire shop should replace the tire and check the wheel for damage from the same impact. 

### Is a tire sidewall bulge always dangerous? 

Yes, a tire sidewall bulge is treated as dangerous because it signals cord damage inside the wall. The bulge can grow as the weakened sidewall flexes, and it can turn into a blowout under load or heat. A technician should inspect the tire before it is driven further. 

### What causes a bulge on a run-flat sidewall? 

A bulge on a run-flat sidewall comes from an impact or from running the tire at low pressure, which pinches and fatigues the stiffened wall. The reinforced sidewall carries the vehicle load, so damage to its cords shows as an outward swelling. Hitting a curb or a pothole is a frequent trigger. 

### When should a run-flat tire be replaced after sidewall damage? 

A run-flat tire should be replaced as soon as a bubble, bulge or separation appears on the sidewall. Sidewall damage cannot be patched and the wall keeps weakening with every mile. A technician can confirm the damage and fit a matching replacement tire.
