# Rim Contour Codes: J, JJ and JK Flange Designations

Rim contour codes such as J, JJ and JK name the shape of the flange and bead seat. Learn what each letter tells you about wheel fitment and tire seating.

A rim contour code such as J, JJ or JK identifies the profile shape of the rim flange and bead seat that holds the tire. The letter is part of the ETRTO rim contour standard and is printed alongside the [rim width and diameter](/articles/wheel-measurements-explained-diameter-width-offset-and-more/), for example 7J or 6JJ. This page explains what the J, JJ and JK flange designations mean, how the profile differs between them, and why the letter must match the tire and the vehicle. 

## What the flange letters describe 

The letter in a rim contour code describes the cross-sectional shape of the rim flange and the bead seat that supports the tire. The flange height and flange shape control how the tire bead is held and guided onto the rim. A J contour, a JJ contour and a JK contour share the same basic hook flange profile, with differences in flange height and contour radius. The ETRTO rim contour standard fixes these dimensions so that a tire and rim from different makers can be matched. 

## Differences between J, JJ and JK 

The J, JJ and JK contours differ mainly in flange height and the shape of the flange tip. JJ and J contours are close in profile, while the JK contour has a lower flange and a slightly different bead seat shape. A lower flange helps guide the tire bead during mounting and reduces the chance of damage to the bead. The rim width allowed with each profile also differs, and the rim manufacturer sets the limits in the rim profile standard. 

## Why the contour code matters for fitment 

A rim contour code must match the tire bead and the vehicle so that the bead seats properly on the rim. Fitting a tire to a rim with a different contour can leave the bead poorly seated or damage the tire during inflation. Before mounting, check the contour letter against the tire maker's [rim width range](/articles/approved-rim-widths-by-tire-size-checking-tire-and-rim-compatibility/) and the vehicle specification. Where the specified contour is unclear, ask a trained tire technician or the wheel maker for the correct fitment. 

## Questions about rim contour codes 

### What does the J in a rim contour designation mean? 

The J in a rim contour designation names a specific flange and bead seat profile under the ETRTO rim contour standard. A J contour has a hook flange shape with a set flange height that holds the tire bead on the rim. The letter sits next to the rim width, so a 7J rim is 7 inches wide with a J contour. The letter tells you the profile shape, not the width or the diameter. 

### What is the difference between J and JJ rim contours? 

The J and JJ rim contours are close in shape and differ mainly in the flange height and the bead seat contour. Both use a hook flange profile that guides the tire bead onto the rim. The allowed rim width range can differ between the two codes. A tire technician can confirm which contour the tire and vehicle require. 

### What is a JK rim contour? 

A JK rim contour is a flange profile with a lower flange height than the J contour. The lower flange helps the tire bead slide onto the rim during mounting and lowers the risk of bead damage. A JK contour is used on certain passenger-car rim profiles where that flange shape suits the tire. The code appears next to the rim width and diameter. 

### Can I fit a tire on any rim contour code? 

A tire should be fitted only to a rim contour that the tire maker lists for that tire size. A contour that does not match the tire bead can stop the bead from seating correctly on the rim. Check the rim contour standard and the tire maker's rim width range before mounting. Where the contour is in doubt, a trained tire technician should check the fitment.
