# Replacing a Broken Wheel Stud or Lug Stud

How to replace a broken wheel stud or lug stud: pressing the old stud out of the hub flange, drawing a new one in, and checking lug nut retention.

Replacing a broken wheel stud or lug stud means driving the old stud out of the hub flange and drawing a new one into its seat. The job is done from the back of the flange, so access decides how much has to come apart. A damaged stud must be replaced before the wheel goes back on, because the remaining lug nuts cannot hold the wheel alone. 

## Identifying the broken stud 

A broken lug stud shows as a snapped thread or a lug nut that spins without tightening. Inspect every stud on the wheel before ordering a replacement. Stud extraction is easier when the break leaves enough thread for a nut to grip. Replace the stud rather than trimming it, since a shortened stud cannot hold a lug nut safely. 

## Pressing the old stud out 

The old stud passes out through the back of the hub flange, so the hub must be turned to clear it. A press or a sturdy hammer and drift drives the stud through its splined hole. Protect the wheel bearing from hammer blows and never strike the stud while the wheel is on the ground. Some hubs need the brake caliper or bracket moved aside for clearance. 

## Seating a new stud 

A new stud is drawn into the flange with a stack of washers and a lug nut turned against them. The splines must line up straight before the stud is pulled, or the flange hole can be damaged. Tighten until the stud shoulder sits flush against the hub face. Check lug nut retention after the wheel is mounted and the studs are torqued. 

## Questions about broken lug studs 

### Can I replace a broken lug stud without removing the hub? 

Yes, a broken lug stud can often be replaced with the hub in place. The flange must have enough free space behind it for the new stud to slide in. If a brake shield or suspension part blocks that space, the hub has to come off. A trained technician should handle the job when the bearing or hub is disturbed. 

### Is driving with a broken wheel stud safe? 

No, driving with a broken wheel stud leaves the wheel held by fewer lug nuts than the hub was built for. A missing stud also changes the clamping force around the wheel face. Replace the stud before using the vehicle on the road. A wheel that has lost a stud should be checked for further damage. 

### Why did my lug stud break? 

A lug stud breaks when it is stretched or seized, often from over-tightening or a dry thread. Corrosion between the nut and stud can also twist the stud off during removal. A stud that snaps at the threads may have been cross-threaded. Clean threads and the correct torque setting protect the studs. 

### What tools remove a broken lug stud? 

A broken lug stud comes out with a press or a hammer and drift, plus a socket set and a torque wrench for refitting. Stud extraction tools help when the break is below the flange surface. The correct replacement stud must match the thread, length and spline of the old one. Ask a specialist if the flange or bearing shows damage.
