# Radial vs Bias Ply Motorcycle Tires

Learn how radial and bias ply motorcycle tires differ in construction, sidewall markings, size codes and speed ratings so you can read your own tire correctly.

Radial vs bias ply motorcycle tires comes down to how the cords inside the tire are laid out. A bias ply tire runs its cords at an angle across the carcass, while a radial tire runs them straight across from bead to bead. The difference changes how the tire flexes, carries load and appears on the sidewall, and this page explains both types in plain terms. 

## How each carcass is built 

Motorcycle tire construction describes the layers of cord fabric under the rubber, called the carcass. A bias ply tire stacks these cords diagonally, so each layer crosses the one below it and the plies lock together into a stiff structure. A radial tire sets its cords at a right angle to the direction of travel and holds them with belts running around the circumference. The radial layout lets the sidewall flex while the tread stays firm, and the bias layout keeps the whole tire stiffer. 

## Reading radial and bias markings 

Motorcycle radial tire markings tell you which construction you have before you buy. A radial tire carries an R in the size code, as in a size written with the letter between the width and the rim diameter. A bias tire uses a dash in that position or a letter B, depending on the size format. Check the sidewall code carefully, because the letter is the quickest signal of the carcass type. 

## Sizes, load and speed ratings 

Motorcycle bias tire sizes often use a format with a dash, while radial sizes use the R format, so the two are not interchangeable on one rim. The tire speed rating motorcycle figure, shown as a letter after the load index, states the top speed the tire is built to sustain. [Load index and speed rating](/articles/tire-load-index-load-range-speed-ratings-material-44528/) must meet what the motorcycle maker specifies for that machine. Fitting a tire with a lower rating than the maker requires is a safety matter, so match the sidewall figures to the manual. 

## Questions about motorcycle tire construction 

### What is the main difference between radial and bias ply motorcycle tires? 

A radial tire runs its cords straight across the carcass and uses belts to hold the tread, while a bias tire lays its cords diagonally in crossing layers. The radial design flexes more in the sidewall and keeps the tread firmer. The bias design gives a stiffer overall structure with less sidewall give. 

### How do I tell if my motorcycle tire is radial or bias ply? 

A radial motorcycle tire shows the letter R in the size code on the sidewall, placed between the width figure and the rim diameter. A bias tire shows a dash in that spot or the letter B, depending on the size format. Reading the full sidewall code settles the question without guessing. 

### Can I fit a radial tire where a bias tire was original? 

A radial tire should only replace a bias tire when the motorcycle maker approves that change for the model. Rim width, clearance and the suspension are set for a given construction, and mixing types on one bike can upset handling. Follow the owner manual or ask a trained tire specialist before switching. 

### What does the speed rating letter mean on a motorcycle tire? 

A motorcycle tire speed rating is a letter that states the top speed the tire is designed to sustain under load. The rating sits after the load index in the size code on the sidewall. Choose a tire whose load index and speed rating meet or exceed what the motorcycle maker lists for that machine.
