Metric to Standard Tire Size Conversion Chart
Learn how a metric to standard tire size conversion chart works, how to read section width, aspect ratio and rim diameter, and how to find inch equivalents.
Contents
- Reading the metric sidewall code
- How the inch equivalent is built
- Comparing equivalent sizes
- Metric to Standard Tire Size Questions
- How do I convert a metric tire size to inches?
- What is the difference between P-metric and LT sizes and their inch equivalents?
- Is a metric to standard tire size comparison exact?
- Can I use the chart to swap to a different rim diameter?
A metric to standard tire size conversion chart turns a metric sidewall code into an inch-based equivalent size. The metric code gives section width in millimeters, aspect ratio and rim diameter, while the standard code gives overall diameter and width in inches. The chart lets you compare the two formats without guessing at the numbers.
Reading the metric sidewall code
A metric tire size reads as three numbers, such as 225/45R17, and each one carries a different meaning. The first number is section width in millimeters, the second is the aspect ratio, and the last is the rim diameter in inches. Aspect ratio is the sidewall height expressed as a percentage of the section width. The letter between the numbers shows the construction type and internal structure.
How the inch equivalent is built
The standard size designation reports overall diameter and section width in inches, so the metric figures must be converted. Section width in millimeters divides by 25.4 to give inches, and the aspect ratio then gives the sidewall height. Overall diameter adds the rim diameter to twice the sidewall height, and the result is the inch figure you see on the chart. Rounding differences exist between brands, so a chart is a guide rather than an exact match.
Comparing equivalent sizes
An equivalent size chart lists metric sizes next to their inch counterparts so you can see how close two tires come. Two sizes can share a rim diameter and still differ in overall diameter, which changes speedometer readings and clearance. Check section width against the wheel width range and the vehicle body before you treat a pair as interchangeable. A trained tire technician can confirm fitment when a listed equivalent is only close.
Metric to Standard Tire Size Questions
How do I convert a metric tire size to inches?
Metric to standard tire size conversion uses the sidewall numbers, not a single formula for the whole code. Multiply the section width by the aspect ratio to get sidewall height, then divide by 25.4 to change millimeters to inches. Add twice that sidewall height to the rim diameter for the overall diameter in inches.
What is the difference between P-metric and LT sizes and their inch equivalents?
P-metric sizes are passenger car tire codes, and LT sizes are light truck codes, both written in metric form on the sidewall. Their inch equivalents describe the same dimensions in the older standard format of overall diameter and width. The P or LT prefix also signals the load and service category, which the inch number alone does not show.
Is a metric to standard tire size comparison exact?
A metric to standard tire size comparison is close but not always exact, because tire makers round dimensions differently. Measured section width and overall diameter can vary between brands that carry the same nominal size. Use the chart to narrow the options, then check the actual tire data for the size you plan to fit.
Can I use the chart to swap to a different rim diameter?
The chart shows equivalent sizes, but changing rim diameter is a separate decision that affects wheel fitment. A larger rim needs a lower aspect ratio to keep a similar overall diameter, and brake and suspension clearance must be checked. Ask a trained tire technician before you fit a size that moves away from the original rim diameter.