Measuring Tires on a Van

Learn how to measure van tires by reading the sidewall size code, checking diameter with a tape, and finding circumference and rolling radius.

3 min read1 viewsMeasuring Tires on a Van
— · 0 votes
Contents
  1. Reading the size code on van tires
  2. Calculating van tire diameter from sidewall dimensions
  3. Tape measure method for a van tire measurement
  4. Questions about measuring van tires
  5. What is rolling radius on a van tire?
  6. How do I check the wheel size on my van?
  7. Can I measure tire diameter while it is on the van?
  8. Why does my measured tire size differ from the sidewall numbers?

Measuring tires on a van begins with the size code molded into the sidewall. A tape measure then confirms the real diameter, circumference and tread width of a mounted tire. The sections below cover reading the code, measuring by hand and using rolling radius.

Reading the size code on van tires

A van tire size code such as 235/65R16C lists width, sidewall height ratio and rim diameter. The first number gives section width, the tire's widest point, in millimeters. The second number is the aspect ratio, which is sidewall height expressed as a share of width. The R marks radial construction, 16 is rim diameter in inches, and C marks a commercial load tire.

Calculating van tire diameter from sidewall dimensions

Van tire diameter can be calculated from the size code before you pick up a tape. Multiply section width by the aspect ratio and divide by 100 to get sidewall height. Double that height, convert it to inches by dividing by 25.4, then add the rim diameter. Multiplying the diameter by pi gives the tire circumference, the distance covered in one turn.

Tape measure method for a van tire measurement

The tape measure method checks real van tire size, which can differ from the printed code. For circumference, mark the tread and the floor with chalk, then roll the van one full turn. The distance between the two floor marks equals the tire's effective rolling circumference under load. Pressure, load and tread wear all change this figure, so record them with each reading.

Questions about measuring van tires

What is rolling radius on a van tire?

Rolling radius is the distance from the wheel center to the ground on a loaded, moving tire. The figure is shorter than half the unloaded diameter because the tread flattens at the contact patch. Speedometers and gearing calculations rely on rolling radius rather than the size printed on the sidewall. Dividing the rolled circumference by two times pi gives a close estimate of this radius.

How do I check the wheel size on my van?

The wheel size on a van appears as the number after the R in the tire size code. Rim width and bolt pattern are often stamped on the back of the wheel itself. Bolt pattern describes the number of wheel studs and the diameter of the circle they form. A vehicle placard, often found on the door frame, lists the original wheel and tire sizes.

Can I measure tire diameter while it is on the van?

Yes, tire diameter can be measured on the van, but the result reflects the loaded shape. A floor-to-top reading comes out shorter than the true diameter because the bottom of the tire flattens. For an unloaded figure, the van must be lifted so the tire hangs free. Lifting a heavy van calls for rated jack stands or a shop lift run by a trained technician.

Why does my measured tire size differ from the sidewall numbers?

A measured van tire often differs from its sidewall numbers because the code describes nominal sizes. Nominal means a design target, while real dimensions vary between brands and tread patterns. Rim width also shifts section width, since a wider rim spreads the sidewalls further apart. Tread wear and low inflation reduce diameter, so check pressure before any measurement.

Read next

Latest articles