# Measuring Tire Size Off the Wheel

Learn how to measure an unmounted tire with a tape measure and turn width, diameter and bead size into a metric or flotation tire size.

[Measuring tire size](/articles/how-to-measure-tire-dimensions/) off the wheel needs only a tape measure and three readings. The readings are tire width, [overall tire diameter](/articles/tire-diameter-chart-in-inches/) and the bead seat diameter at the inner edge. From those numbers you can work out sidewall height and write the size in metric or flotation form. 

## Measuring width and bead diameter 

Tire width, called section width, is measured across the widest point of both sidewalls. Skip raised lettering and rim protector ribs, which add width that is not part of the section. Bead seat diameter is the inside diameter where the tire beads sit on the rim. Measure it straight across the bead opening, then round to the nearest standard rim size in inches. 

## Finding overall diameter and sidewall height 

Overall tire diameter is easiest to find by standing the tire upright on a flat floor. Measure from the floor to the top of the tread, holding the tape vertical through the center. Another method is to wrap the tape around the tread and divide the circumference by 3.1416. Sidewall height equals overall diameter minus bead diameter, divided by two. 

## Turning measurements into a tire size 

A [flotation tire size](/articles/flotation-tire-sizes-sizes-and-dimensions-overview/) lists overall diameter, width and rim diameter in inches, as in 33x12.50R15. A metric size gives width in millimeters, then aspect ratio, then rim diameter, as in 265/70R17. Aspect ratio is sidewall height divided by section width, multiplied by 100. Convert inches to millimeters by multiplying by 25.4 before you calculate the ratio. 

## Questions about measuring unmounted tires 

### Does an unmounted tire measure the same as a mounted one? 

No, an unmounted tire usually measures a little differently from the same tire mounted and inflated. Rim width spreads or narrows the sidewalls, which changes section width. Air pressure and vehicle load also change the overall diameter once the tire is in use. 

### Can I find tire size without reading the sidewall? 

Yes, tire size can be estimated from tape measurements when the sidewall markings are worn or hidden. Measured numbers carry small errors, so rounding to standard sizes is part of the job. Where the sidewall code is still legible, the code gives the exact designated size. 

### Should I take a tire off the rim just to measure it? 

No, a tire can be measured for width and diameter while still mounted on the rim. Bead seat diameter can be read from the rim size often stamped on the wheel. Getting a tire dismounted from the rim calls for a trained technician with a tire changer. Wrong mounting or bead seating can injure a person or damage the wheel. 

### How accurate are tape measure readings on a tire? 

Tape measure readings on a tire are accurate enough to identify a size, not to certify it. Soft rubber, worn tread and a flexing tape each add a small error. Measuring twice at different points around the tire helps spot a reading that is off.
