# Installing Konig Snow Chains

Learn how Konig snow chains go on, why the chain model and tire size must match, and what the instruction manual covers before you drive.

Installing Konig snow chains means matching the chain model to your exact tire size, laying the chain out without twists, and tensioning it as the maker's instruction manual describes. This page explains the fitting steps in plain terms and points out where a wrong size or a loose chain creates trouble. It also covers the checks to make before you drive and the reasons a driver stops partway through. 

## Match the chain model to the tire 

Konig snow chains come in model types built for a range of tire dimensions, so the sidewall size decides which one fits. Read the width, aspect ratio, and rim diameter from the tire sidewall and compare them with the fitment table for that chain model. A chain sold for a nearby size can still sit wrong on the shoulder and rub the sidewall. Tire fitting with brand chains starts with this match, not with the box label alone. 

## Lay the chain out before fitting 

A Konig chain goes on more evenly when it is spread flat first and checked for twists and tangles. The cross links should face the tread and the side hooks should point inward toward the wheel. Work on level ground with the parking brake set and the wheel you are fitting turned outward for access. Keep fingers clear of the gap between chain and tire as you pull the chain over. 

## Tension the chain and recheck it 

The tensioner or elastic fastener holds a Konig chain against the tire, and a slack chain can strike the body or brake parts. Follow the instruction manual for the tension setting on your model, then roll the vehicle a short distance and check the chain again. Retensioning after that first roll takes little time and catches a chain that has settled into the tread. A chain that still sits loose after adjustment points to the wrong size. 

## Questions About Fitting Konig Chains 

### Do Konig snow chains fit any tire? 

Konig [snow chains fit](/articles/snow-chain-clearance-how-to-check-tire-and-wheel-fitment/) only the tire sizes listed for each chain model, so no single chain covers every tire. Check the fitment table against the width, aspect ratio, and rim diameter on your sidewall. A chain that is too large hangs loose, and one that is too small will not close around the tread. 

### What does the instruction manual for Konig chains include? 

The instruction manual for a Konig chain covers the parts in the kit, the fitting order, and the tension setting for that model. It also lists the tire sizes the chain suits and the driving limits the maker sets. Read it before the first fitting, because details vary between chain model types. 

### Can I fit snow chains without moving the car? 

Snow chains can be fitted with the car parked, but the chain usually needs a short roll to settle before final tensioning. Fit the chain on the driven wheels with the parking brake set and the wheel turned out. Then move the vehicle a short distance and check the tension again. 

### Why does my Konig chain sit loose after fitting? 

A loose Konig chain often means the model does not match the tire size, or the tensioner is not set as the manual describes. Check the fitment table first, then reset the tensioner and recheck after a short roll. A chain that stays slack should come off before you drive.
