# How to Change Tire Size Yourself

Learn how to change tire size yourself: check sidewall markings and rim compatibility, confirm clearance, mount and seat the bead, and torque the wheel nuts.

Changing tire size yourself means fitting a replacement tire whose sidewall dimensions differ from the original, and it starts with reading the size markings and confirming the new tire fits the rim and the vehicle. The job combines wheel removal, tire mounting and bead seating with a final check of clearance, inflation pressure and speedometer calibration. A trained specialist handles balancing and any work that needs a tire machine. 

## Read the sidewall before you buy 

Sidewall size markings give the width, the aspect ratio and the rim diameter the tire is built for. A replacement tire dimension must match the rim diameter exactly if you intend to reuse the same wheel. [Load index and speed rating](/articles/tire-load-index-load-range-speed-ratings-material-44528/) also belong to the size decision, because a smaller or lighter tire can carry less. Write the numbers down and compare them with the vehicle placard before you order anything. 

## Check rim compatibility and clearance 

Rim compatibility covers the wheel width range the new tire accepts, and a tire wider than the rim allows will not seat correctly. Larger tire fitment also depends on clearance to the suspension, the inner fender and the brakes through the full steering travel. Turn the wheels lock to lock and look for contact before the vehicle leaves the jack. A test fit with the car on the ground settles questions the eye cannot answer in the air. 

## Mount, seat and torque in order 

Jack up the vehicle on firm level ground and loosen the lug nuts before the wheel lifts off the surface. Remove the old tire, mount the new one on the rim and seat the bead with air until the sidewall sits evenly against the flange. Lower the car and torque wheel nuts to the figure the vehicle maker specifies, using a calibrated wrench. Tire mounting and balancing need a trained specialist when the bead will not seat or the wheel needs weights. 

## Questions about a DIY tire size change 

### Can I mount a new tire size myself at home? 

Mounting a new tire size yourself is possible with hand tools, but seating the bead safely demands care. A tire that will not seat at the pressure you apply needs a specialist with a proper machine, because over-inflation to force the bead can injure you. Balancing the wheel afterwards also needs equipment most home garages do not hold. 

### What tools do I need for a DIY tire change? 

Tools for changing tire size include a jack and stands, a lug wrench or impact wrench, a torque wrench, tire levers and a bead lubricant. A pressure gauge and a compressor with enough volume to seat the bead belong in the kit as well. A trained specialist provides the tire machine and balancer when the job goes beyond a simple swap. 

### How does a larger tire size affect the speedometer? 

A larger tire size changes the distance the wheel covers in one turn, so the speedometer reads lower than the true road speed. Speedometer calibration corrects the reading after the change, and some vehicles accept a setting through their electronic controls. Check the reading against a known reference before you trust it on the road. 

### How tight should the wheel nuts be after a tire size change? 

Wheel nuts go to the torque figure the vehicle maker lists for that model, not to a guessed tightness. Tighten them in a star pattern in stages so the wheel sits evenly against the hub. Recheck the torque after the first drive, because a wheel that shifts can loosen its nuts.
