# How to Change a Flat Tire on a Bicycle

Step-by-step guidance to change a flat bicycle tire: remove the wheel, free the tire, swap or patch the tube, and refit it with the right valve and pressure.

Learning [how to change a flat tire](/articles/how-to-change-a-flat-tire-on-a-car/) on a bicycle comes down to a short sequence you can repeat anywhere: take the wheel off, free one side of the tire, pull the tube, fit a new or patched tube, and seat everything back on the rim. The job needs a spare tube, tire levers and a pump, and it works the same on a road bike as on any other bicycle apart from small differences in the wheel and valve. This page walks through each stage and explains the checks that keep the repair sound. 

## Removing the wheel from the frame 

Wheel removal is easier once you know which release your bicycle uses. A quick-release lever flips open and the wheel lifts out, while a bolted axle needs a wrench for the axle nuts. On a rear wheel, shift the chain onto the smallest sprocket first so the derailleur gives the wheel room to drop. Open the brake if the tire will not pass the brake pads. 

## Levers, tire and tube 

Tire levers hook under the tire bead and lift it over the rim edge. Push one lever down and clip it to a spoke, then run a second lever around the rim to free one side of the tire. Pull the tube out through the gap and note how it sits, so you know the orientation for the refit. Keep the tire on the rim on the far side, because that holds the wheel together. 

## Valve type and inflation 

The valve type decides which pump head you need and how the tube connects. A Schrader valve takes a push-on head, while a Presta valve needs its small nut unscrewed before the pump fits. Seat the new tube inside the tire, work the bead back onto the rim by hand, and check that no tube is pinched under the bead. Inflate in stages and stop if the tire sits unevenly on the rim. 

## Questions about bicycle flat tire repair 

### How do I change a flat tire on a road bike? 

Changing a flat tire on a road bike follows the same steps as any bicycle, with narrow tires that need care. Use thin tire levers, keep the tube away from the rim edge, and seat the bead by hand before you pump. Road tires hold high pressure, so inflate in small stages and check the bead line around the rim as pressure rises. 

### Do I need a patch kit or a spare tube? 

A spare tube is the faster choice at the roadside, because you swap it in and deal with the damaged one later. A patch kit repairs a punctured tube and saves space in a small bag, but the glue needs time to set before you inflate. Carrying both covers a second flat on the same ride. 

### How do I know which valve type my tube has? 

The valve type is visible at the rim as either a narrow metal pin with a small nut or a wider valve like the one on a car tire. A Presta valve is the thin one with a lock nut, and a Schrader valve is wider and takes a push-on pump head. Match the new tube to the valve hole in the rim so it fits cleanly. 

### Why did my new tube go flat right away? 

A new tube often fails because something sharp stays inside the tire or the tube is pinched under the bead. Run a finger carefully around the inside of the tire to find the cause, and check the rim tape that covers the spoke holes. Fit the tube with a little air in it, then seat the bead by hand before pumping.
