# Confirm Tire Size Markings

Learn how to confirm tire size markings on the sidewall, read the size code step by step, and verify dimensions before buying or fitting a tire.

Confirming tire size markings means reading the size code on the tire sidewall and matching it to the vehicle, so the replacement fits correctly. This page walks through the sidewall numbers, the size format, and the checks to make before you buy or fit a tire. 

## Read the sidewall size code 

The tire sidewall carries a size code such as P205/55R16, and each part of that code has a meaning. The letter or letters at the front show the tire type, with P-metric and LT codes naming passenger and light truck designations. The first number is the section width in millimeters, the number after the slash is the aspect ratio, and the letter R shows radial construction. The final number is the rim diameter in inches, which is the size of wheel the tire seats on. 

## Check the door jamb placard 

The vehicle placard on the door jamb lists the tire size the manufacturer specifies for that car. Compare the sidewall code to the placard size before you order or fit a replacement. The owner's manual repeats the same size information and adds the [load index and speed rating](/articles/tire-load-index-load-range-speed-ratings-material-44528/) for the vehicle. A rental car or a van often has its own placard, so check that vehicle's sticker rather than assuming a shared size. 

## Verify load index and speed rating 

The load index and speed rating sit at the end of the size code and must match or exceed what the vehicle needs. Load index is a code for the maximum load a tire carries, and speed rating is a letter for the maximum speed it sustains. A size that matches in width and diameter but falls short on these two figures is not a correct fitment check. Electric vehicle tire identification sometimes adds markings that point to a higher load requirement. 

## Questions About Tire Size Checks 

### How do I check tire size on my car? 

You check tire size on your car by reading the sidewall code and comparing it to the door jamb placard. The placard lists the size the manufacturer specifies, and the sidewall shows what is fitted now. When the two differ, the placard governs what the car should carry. 

### Can I do a quick tire size check at night? 

A night time tire check works with a flashlight held close to the sidewall so the raised numbers catch the light. Move the light across the markings at an angle, because low light makes the size code hard to read straight on. Wipe dirt from the sidewall first, since grime fills the grooves of the numbers. 

### How do I verify tire size before ordering? 

Verify tire size before ordering by writing down the full sidewall code and matching it to the vehicle placard or owner's manual. Order only when the section width, aspect ratio, rim diameter, load index and speed rating all agree. A tire shop or the seller's customer service can confirm the size code if a marking is worn. 

### What do the digits on a tire sidewall mean? 

The digits on a tire sidewall give the tire dimensions in a fixed order. Section width comes first in millimeters, aspect ratio follows as a percentage of that width, and rim diameter closes the code in inches. The load index and speed rating follow the size code as separate figures.
