# Comparing Tire Diameters: How to Compare Overall Diameter Between Tire Sizes

Learn how to compare overall tire diameter between sizes using the sidewall code, then work out the difference in inches and as a percentage.

Comparing tire diameter means working out the overall height of each tire from its sidewall size code and setting the two results side by side. The numbers on the sidewall give section width, aspect ratio and rim diameter, which together define overall diameter. This page shows how to convert those figures to inches, measure the gap between two sizes, and judge whether a pair is close enough to interchange. 

## Reading the sidewall to find diameter 

The sidewall size code carries the three figures that set overall diameter: section width in millimeters, aspect ratio as a percentage, and rim diameter in inches. Sidewall height equals section width multiplied by the aspect ratio, divided by one hundred. Overall tire diameter is rim diameter plus twice that sidewall height, which is tire height expressed in inches. A larger aspect ratio on the same width raises the sidewall and the total diameter. 

## Doing the diameter difference calculation 

A diameter difference calculation subtracts one overall diameter from the other and divides by the first to get a percentage difference. The sign tells you whether the new tire is taller or shorter, and the percentage tells you how much. Percentage difference matters more than the raw figure, because a small gap on a tall tire is a larger share than the same gap on a short one. Compare results in inches for clearance and in percent for speedometer error from a diameter change. 

## Same diameter, different width sizes 

Tires can match in overall diameter while differing in section width, which is what equal diameter tire sizes describes. Width changes the footprint and the sidewall profile, while the height stays close if the aspect ratio shifts the other way. These constant diameter tire sizes fit the same rim diameter and keep the rolling circumference close, so the speedometer reads nearly the same. Check rim width and clearance before treating two such sizes as interchangeable. 

## Tire Diameter Comparison Questions 

### How do I compare tire diameters from the size numbers? 

You compare tire diameters by converting each size code to overall diameter in inches. Multiply section width by aspect ratio, divide by one hundred for one sidewall, then add twice the sidewall to the rim diameter. Put the two totals side by side to see which tire is taller. The sidewall numbers drive the result more than the rim figure alone. 

### Can tires of the same diameter but different width be interchanged? 

Same diameter tires can be interchangeable in height, but width decides whether they fit the rim and the wheel well. A wider tire needs a rim wide enough to support the bead and enough clearance to avoid rubbing. If the overall diameter matches, the speedometer stays close and the rolling diameter stays near the original. Confirm [rim width range](/articles/approved-rim-widths-by-tire-size-checking-tire-and-rim-compatibility/) and clearance with a tire specialist before fitting. 

### How do I calculate the percentage difference between tire sizes? 

The percentage difference between tire sizes is the diameter gap divided by the original diameter, multiplied by one hundred. Use the taller measurement as the reference when you want the size of the change from the starting tire. A positive result means the new tire is taller, and a negative one means it is shorter. This percentage is what drives speedometer error from a diameter change. 

### What is tire diameter comparison to inches? 

[Tire diameter comparison](/articles/tire-size-calculator-diameter-comparison-material-44527/) to inches converts the metric sidewall figures into an inch total for overall diameter. Section width arrives in millimeters, so millimeter and inch conversion is needed before you add the rim diameter, which is already in inches. Divide millimeters by twenty five point four to get inches for the width. The finished overall diameter then sits in the same unit as the rim.
