# Comparing Farm Tire Sizes Side by Side

Read farm tire sidewall codes and compare tractor tire sizes side by side: overall diameter, section width, rolling radius, and radial versus bias construction.

Comparing farm tire sizes side by side means reading the sidewall size codes on two agricultural tires and matching their dimensions, not their labels. The code gives section width, aspect ratio, rim diameter, and often the intended rim and construction. Once you convert each code into real dimensions, you can see where two tires differ in overall diameter, tire height, and section width. That comparison guides a swap, a match, or an axle pairing without guesswork. 

## Decoding the sidewall size codes 

Sidewall size codes on agricultural tires pack several measurements into one string of numbers and letters. A typical code states section width, aspect ratio, rim diameter, and the load and speed symbols that complete it. Some farm tires use a simple inch format that gives overall diameter and section width directly. Knowing which format you are reading stops you from comparing two numbers that mean different things. 

## Working out overall diameter and tire height 

Overall diameter is the full height of the mounted tire from ground to top, and [tire height comparison](/articles/tire-size-calculator-diameter-comparison-material-44527/) depends on it. You can calculate it from the [sidewall aspect ratio](/articles/tire-aspect-ratio-what-the-ratio-on-a-tire-size-means/) and rim diameter, then add the two sidewall heights to the rim. A size comparison calculator is just this arithmetic done twice and placed next to each other. Two tires with the same rim diameter can still sit at different heights, which changes clearance and gear ratio. 

## Rolling radius, section width, and construction 

Rolling radius is the distance from the axle center to the ground under load, and it is smaller than half the overall diameter. Radial and bias agricultural tires deflect differently, so their rolling radius and section width comparison can vary even at the same printed size. Section width tells you how much room the tire needs across the axle and frame. Compare these mounting dimensions too, because a wider tire can foul a fender or a loader arm. 

## Farm tire size comparison questions 

### How do I compare two farm tire sizes side by side? 

Farm tire size comparison starts by decoding each sidewall code into section width, aspect ratio, and rim diameter. Calculate overall diameter for both tires and place the results beside each other. Then compare section width to check frame and fender clearance. Do the same for rolling radius if the tires will share an axle or a drive line. 

### What does a tractor tire size comparison calculator actually do? 

A tractor tire size comparison calculator converts a sidewall code into dimensions and shows them next to a second size. It calculates overall diameter, sometimes rolling radius, and section width from the numbers you enter. Check what the tool assumes about aspect ratio and rim width, because a wrong input gives a wrong comparison. The calculator does not measure a worn tire; it works from the code. 

### Why can two tires with the same size code sit at different heights? 

Two tires with the same printed size can differ in overall diameter because of construction, inflation, and load. A radial agricultural tire and a bias one deflect differently, so their rolling radius changes at the same pressure. Rim width also alters how the section width and height sit. Measure the mounted tire if exact height matters for your machine. 

### What is the difference between overall diameter and rolling radius? 

Overall diameter is twice the distance from the axle center to the top of an unloaded tire. Rolling radius is the loaded distance from the axle center to the ground, so it is smaller. Tire height comparison for clearance uses overall diameter, while speed and gearing depend on rolling radius. Use the loaded value when the tire carries the machine.
