Calculating Tire Tread Wear Percentage
Learn how to figure out percent tread remaining by dividing remaining tread depth by the original tread depth, and see what each result means for a tire.
Contents
- Find the original tread depth
- Apply the tread wear percentage formula
- Read the numbers with care
- Questions About Tread Wear Percentage
- How do you calculate tire tread percentage?
- What does percent tread remaining mean?
- Where do I find the original tread depth for my tire?
- Does a tire wear percentage calculator give the exact tread left?
Calculating tire tread wear percentage means comparing the tread depth left on a tire to the depth it had when new. You measure the remaining depth, divide it by the original tread depth, multiply by one hundred, and read the result as the percent of tread still there. Subtracting that figure from one hundred gives the percent of tread worn.
Find the original tread depth
Original tread depth is the depth of the grooves on a tire when it is new, and it is the baseline for every percentage you work out. Tire makers quote it in 32nds of an inch or in millimeters, so note which unit your gauge uses. A depth gauge reads the distance from the top of the tread block down to the groove floor. Use the same unit for the original and the remaining figures, or convert one before you divide.
Apply the tread wear percentage formula
The tread wear percentage formula divides remaining tread depth by original tread depth, then multiplies by one hundred. If a tire keeps half of its starting depth, for example, the percent tread remaining is fifty. Subtract that number from one hundred to get the percent of tread worn. A tread wear calculator applies these same steps, so you can check your own arithmetic against it.
Read the numbers with care
Wear percentage describes how much rubber has gone, not how safe a tire is, so pair it with the legal tread limit where you drive. Wear bars molded into the grooves show when a tire is at that limit, and a trained technician can confirm the reading. Measure in several grooves across the tread, because a tire can wear unevenly from side to side. Uneven wear points to an alignment or inflation problem that needs attention before you trust one figure.
Questions About Tread Wear Percentage
How do you calculate tire tread percentage?
Tire tread percentage is calculated by dividing the remaining tread depth by the original tread depth and multiplying by one hundred. Measure both depths in the same unit, either 32nds of an inch or millimeters. The answer tells you what share of the original tread is still on the tire.
What does percent tread remaining mean?
Percent tread remaining means the share of the original tread depth that is still on the tire. A reading near one hundred means little rubber has worn away. A lower number means more of the tread has been used up.
Where do I find the original tread depth for my tire?
The original tread depth for a tire comes from its manufacturer, since new depth differs between tire designs and sizes. Check the maker's published specification for your exact tire model. A tire shop can also confirm the figure when it measures your tread.
Does a tire wear percentage calculator give the exact tread left?
A tire wear percentage calculator gives an accurate figure only if your depth readings are accurate. Measure at several points across the tread and in more than one groove, because wear is rarely even. The calculator does the arithmetic, but the gauge readings supply the real data.