# Autocross Tire Width and Size

How autocross tire width, aspect ratio and rim diameter work together, how to read sidewall markings, and what to check before fitting a set for an event.

Autocross tire width and size decide how much rubber meets the course and whether the wheel and body will accept it. This page explains the sidewall numbers, how [width and aspect ratio](/articles/comparing-tire-width-and-aspect-ratio/) combine, and the fitment checks that matter before you mount a set of autocross tires. 

## Reading the sidewall markings 

Sidewall numbers on a tire describe its size in a fixed order, so you can compare two tires without guessing. The first figure is the [tire section width](/articles/tire-width-chart/) in millimeters, measured across the widest part of the inflated tire. The second figure is the aspect ratio, which is the sidewall height expressed as a percentage of the section width. The last figure is the rim diameter in inches, so a size such as 245/40R18 means a 245 mm section, a sidewall at 40 percent of that width, and an 18 inch wheel. 

## How width and sidewall interact 

Autocross tire width and sidewall size work as a pair on the same wheel. A wider section on the same rim spreads the sidewall and gives a squarer shoulder, which changes how the tire takes load in a turn. A taller aspect ratio adds sidewall height, and that extra flex can alter steering response and how the car settles mid-corner. Moving to a wider tire often means stepping down the aspect ratio to keep the overall diameter close to the original. 

## Fitment checks before you mount 

Autocross tire fitment starts with the rim, because every tire size has a recommended [rim width range](/articles/approved-rim-widths-by-tire-size-checking-tire-and-rim-compatibility/) for safe seating. Check the wheel width against that range, then confirm the tire clears the suspension, brake calipers and inner fender at full steering lock and full compression. Body clearance matters too, since a wide section can rub the fender lip under cornering load. Competition rules for the class can limit the tire dimensions you may run, so read the rulebook before buying. 

## Autocross tire size questions 

### What does the aspect ratio mean on an autocross tire? 

The aspect ratio is the sidewall height shown as a percentage of the tire section width. A 245/40 tire has a sidewall equal to 40 percent of its 245 mm width, which works out to 98 mm. A lower aspect ratio gives a shorter sidewall on the same width, and a higher one adds sidewall height and flex. 

### Can I fit a wider tire on my stock wheel? 

A wider tire can fit a stock wheel only if the wheel width falls within the rim range the tire maker lists for that size. Pushing a wide section onto a narrow rim pinches the sidewall and changes the contact patch shape. Check the recommended rim width for the exact tire before mounting anything. 

### What tire dimensions should I check before an event? 

Tire dimensions to check are the section width, the aspect ratio, the rim diameter and the resulting overall diameter. Compare the overall diameter with your original size to see how gearing and clearance change. Also confirm the class rules allow the size you plan to run, because some classes cap tire width. 

### Does tire width change the autocross class I run in? 

Tire width can change your autocross class, because many classes set limits on section width or on the treadwear rating of the tire. Class rules vary by organization, so read the current rulebook for your class. Confirm the allowed dimensions before you buy a set.
